Chapter 1. Introduction
Fibre Channel Library Rear Panel Components
Ethernet port
Fibre | Drive SCSI IDs |
|
| Fuse | Serial |
Channel |
| Library | Library | lights | port |
port |
| SCSI ID | configuration |
| Power |
|
|
|
|
| connector |
Figure 1-5 The Fibre Channel library’s rear panel components.
Fibre Channel Port The Fibre Channel port allows you to choose between three GBICs for your library cabling.
Ethernet Port This port allows Spectra Logic support technicians to gain information about your library.
Drive SCSI IDs The drive SCSI ID switches control the SCSI IDs for installed tape drives. SCSI ID settings for uninstalled tape drives are ignored by the library.
Note: Do not change the default settings for the drives (2, 3, 4, and 5). If the default settings are changed, the drives will not be recognized.
Library SCSI ID The library SCSI ID switch sets the SCSI ID for the library itself.
Note: Do not change default SCSI ID (6) for the library. If the default setting is changed, the robotics will not be recognized.
16
