Chapter 4. Configuring the Library

Time

Set the time from the first Configuration screen. To get there from the main screen, press Config. This procedure sets only the time the displayed on the library’s front panel; it does not affect any time settings used by the host or backup software.

To set the time:

1.Press the + or - symbols on either side of the 12/24 Hour Time button, depending on the format in which you want the time displayed. The enabled setting of 12 or 24 appears next to the button.

2.Press the Set Time button. The Set Time dialog appears.

3.Enter the hour (a number between 0 and 23, depending on whether you have chosen 12-hour or 24-hour time), then touch OK.

4.Enter the minutes (a number between 0 and 59), then touch OK.

5.Enter the seconds (a number between 0 and 59), then touch OK.

6.Touch Save Parms > No; the changes are saved without restarting the library.

Note: Touch Back to backspace over an entered number. Touch Exit to cancel changes without saving and return to the configuration screen.

Library Emulation

The library can emulate other library types for compatibility with your host system. Set the library emulation from the second Configuration screen; to get there from the main screen, press Config > More.

1.Touch the + or - symbols to view the available choices.

2.Select the emulation you want, then touch Save Parms > Yes; it is necessary to restart the library for these changes to take effect.

RS-232 Handshake

Set serial port handshaking from the second configuration screen; from the main screen, press Config > More. If you are not using a backup package which requires a serial connection between the library and the host, you can ignore this setting.

Touch + to enable hardware handshaking on the serial port, or touch - to disable handshaking.

Touch Save Parms > No, because it is not necessary to restart the library for these changes to take effect.

49

Page 49
Image 49
Spectra Logic 10000 manual Time, Library Emulation, RS-232 Handshake