Chapter 1. Introduction
SCSI Library Rear Panel Components
SCSI Port 1 IN | SCSI Port 1 OUT |
SCSI Port 2 IN | Drive SCSI IDs |
| Fuse | Serial |
|
| Library | lights | port |
SCSI Port 2 OUT | Library |
| Power | |
Configuration | ||||
| SCSI ID |
|
| connector |
Figure 1-4 The SCSI library’s rear panel components.
SCSI Ports The four SCSI ports enable you to connect the library as a device on a SCSI bus, and attach terminators for proper device termination.
Drive SCSI IDs The SCSI ID switches control the SCSI IDs for installed tape drives. SCSI ID settings for uninstalled tape drives are ignored by the library.
Library SCSI ID The library SCSI ID switch sets the SCSI ID for the library itself.
Library Configuration The library configuration switch determines the operating mode of the library. The library configuration switch default setting is 0.
Fuse Lights There are three fuse lights, one for each fuse. When you need to replace one of the library fuses, the appropriate fuse light will light up.
Serial Port The
Power Connector The power connector provides a port for AC power.
15
