Furuno GP32 manual Speed Alarm, WAAS/DGPS Alarm, Time Alarm, WAAS/DGPS mode and alarm message

6.3 Speed Alarm

The speed alarm provides visual and aural alerts when the ship’s speed is higher (or lower) than the alarm range set.

1.Press the [MENU] key once or twice to open the menu.

2.Choose ALARMS.

3.Press the [ENT] key.

4.Choose SPEED and then press the [ENT] key.

5.Choose LOW or HIGH as appropriate and then press the [ENT] key.

LOW: Alarm sounds when speed is lower than speed set.

HIGH: Alarm sounds when speed is higher than speed set.

6.Press the [ENT] key. Enter speed (0.0-999.9 kt) with the cursor pad.

7.Press the [ENT] key.

8.Press the [MENU] key twice to finish.

When the speed alarm setting is violated, the buzzer sounds and the message SPD ALARM! and the alarm icon appear.

6. ALARMS

When the DGPS/WAAS signal is lost, the buzzer sounds and a message (see table below) and the alarm icon appear. Further, the default position is shown.

WAAS/DGPS mode and alarm message

MODE on	Alarm condition, alarm
WAAS/DGPS
	message
menu
	Alarms released when
	receiver status changes from
WAAS	W2D or W3D to 2D or 3D.
	“WAAS ERROR!” and the
	alarm icon appear when this
	occurs.
	Alarms released when
	receiver status changes from
INT BEACON,	D2D or D3D to 2D or 3D.
EXT BEACON	“DGPS ERROR!” and the
	alarm icon appear when this
	occurs.
	Alarms released when
	receiver status changes from
AUTO	D2D, D3D, W2D or W3D to
	2D or 3D. “WAAS/DGPS
	ERROR!” and the alarm icon
	appear when this occurs.

6.4 WAAS/DGPS Alarm

This alarm alerts you by aural and visual alarms when the WAAS/DGPS signal is lost. Note that ON cannot be selected if “MODE” in the WAAS/DGPS menu is set to GPS.

1.Press the [MENU] key once or twice to open the menu.

2.Choose ALARMS.

3.Press the [ENT] key.

4.Choose WAAS/DGPS and then press the [ENT] key.

5.Choose ON.

6.Press the [ENT] key.

7.Press the [MENU] key twice to finish.

6.5 Time Alarm

The time alarm works like an alarm clock, releasing audio and visual alarms when the time entered has come.

1.Press the [MENU] key once or twice to open the menu.

2.Choose ALARMS.

3.Press the [ENT] key.

4.Choose TIME and then press the [ENT] key.

5.Choose ON and then press the [ENT] key.

6.Press the [ENT] key.

7.Enter time desired with the cursor pad.

8.Press the [ENT] key.

9.Press the [MENU] key twice to finish.

When the time entered has come, the buzzer sounds and the message TIME ALARM! and the alarm icon appear.

31