Furuno GP32 Satellite Monitor Display, Diagnostics, Satellite monitor display, Test START? prompt

8.5 Satellite Monitor Display

The satellite monitor display shows information about GPS and GEO satellites.

1.Press the [MENU] key once or twice to open the menu.

2.Choose SATELLITE.

3.Press the [ENT] key.

Number, bearing and elevation angle of all GPS and GEO satellites (if applicable) in view of your receiver appear. Satellites being used in fixing position are displayed in reverse video; satellites not being used are shown in normal video.

												Receive signal level
	Receiver											Bars show signal level.
												Satellites whose signal
	status
												level extends past the
	(See page 2.)
												dashed line are used
							North					in fixing position.
								DOP value
		D3D
Elevation										DOP		01
						N		1. 5
45°											- -			02
						07
								06							04
											05
		02
					08						06
											07
									04
														08
	10										- -
				12
								05			- -			10
		01				W
														12
		85m											122
																GEO satellite
				GEO
				satellite
								Satellite number in reverse
			Altitude
								video is used for positioning.
	Elevation 5°

Satellite monitor display

4.Press the [MENU] key twice to quit the SATELLITE display.

8. MAINTENANCE & TROUBLESHOOTING

8.6 Diagnostics

The diagnostic test checks ROM, RAM, data port, beacon receiver, battery, RTC, keyboard and LCD for proper operation.

1.Press the [MENU] key once or twice to open the menu.

2.Choose SYS SETUP and then press the [ENT] key.

3.Choose “TEST?” and then press the [ENT] key. You are asked if you are ready to start the test.

TEST START ?

(STOP: PWR OFF)

ARE YOU SURE ?

YES NO

TEST START? prompt

4.Press ◄ to choose YES and then press the [ENT] key to start the test.

5.The equipment tests ROM, RAM, data port, beacon receiver, internal battery and RTC. The results are individually displayed as OK or NG (No Good).

TEST

ROM	:	OK
RAM	:	OK
DATA2	:	- - (STOP: PWR OFF)
BEACON	:	OK 085-0182-0XX
BATTERY :		OK
RTC	:	OK 205-1412-0XX
CNT: 001		205-1411-0XX

XX = Program version no.

TEST results (GP-37)

Note 1: BEACON test result shown as NONE when no beacon receiver is connected to the GP-32.

Note 2: DATA2 requires a special connector to check. “- -” appears as the result when no connector is connected.

Note 3: No program number shown for BEACON in case of the GP-32.

Note 4: CNT shows the number of times the test has been executed consecutively.

49