Furuno GP32 manual Clearing Data

8. MAINTENANCE & TROUBLESHOOTING

6.After the equipment has displayed the test results, a beep sounds and the message PUSH KEY appears at the top right-hand corner.

7.Press each key one by one. The name of the key pressed momentarily appears at the top right-hand corner if the key is functioning properly.

Note: If no key is pressed within approx. five seconds, the equipment automatically proceeds to step 8.

8.The equipment displays the following message to inform you that it is now going to check the LCD:

<LCD CHECK>

ALL ON 2 SEC.

ALL OFF 3 SEC.

LCD check

9.The LCD is checked, and then the test is repeated. To stop the test, turn off the power.

8.7 Clearing Data

You may clear GPS data, menu settings and all backup data to start afresh.

1.Press the [MENU] key once or twice to open the menu.

2.Choose ERASE and then press the [ENT] key.

3.Choose GPS DATA, MENU SETTINGS, or ALL BACKUP DATA as appropriate and then press the [ENT] key. One of the following messages appears.

ERASE GPS DATA?

ARE YOU SURE?

YES NO

GPS DATA

MENU SETTINGS

TO DEFAULT?

ARE YOU SURE?

YES NO

MENU SETTINGS

ERASE ALL BACKUP

DATA? (DEFAULT)

ARE YOU SURE?

YES NO

BACKUP DATA

Prompt for erasure of GPS data, menu

settings, backup data

4.Press ◄ to choose YES and then press the [ENT] key. The following display appears.

RESTART FOR

ERASING DATA.

PUSH ANY KEY.

Prompt for restarting

5.Hit any key to erase item selected. A beep sounds while the selected item is being erased.

Note 1: If you were using the simulation mode when data is cleared, the message “Start Simulation – Are You Sure? appears. Choose YES and press the [ENT] key to start the simulation mode, or press the [ENT] key to start normal operation

50