RCA Pro847, Pro848, Pro842 manual Install the Clock Lithium Cell, Install Cell, Remove Cell

Recording

Install the Clock Lithium Cell

The clock cell indicator 88:88 will flash for a few seconds in the viewfinder when you turn on the camcorder if the cell has not been installed or needs to be replaced.

Install Cell

1.Make sure camcorder is turned off, and remove any power supply attached to the camcorder.

2.Pull our the clock cell holder.

3.Insert the clock cell with the “+” terminal facing up in the cell holder.

4.Replace the clock cell holder. It will click into place.

Clock Cell

Holder

Remove Cell

To remove cell, slide the cell out of the cell holder.

Cautions: Lithium cell. Replace only with 3-volt lithium cell – such as CR2025. Use of other cell presents a risk of fire or explosion. Must be disposed of properly. Never handle punctured or leaking cell. May cause burns or personal injury.

Keep out of the hands of children. Can cause death or injury if swallowed. If swallowed, consult a physician immediately for emergency treatment.

The lithium cell used in this device may explode resulting in a fire or chemical burn if mistreated. Do not recharge, disassemble, heat above 212˚F (100˚C), or incinerate.

Never use metallic tweezers to hold the cell, and never short circuit the + and – sides of the cell.

27