Powering Your Camcorder
Using the Optional AC Adapter/Charger
The optional CPS801C AC adapter/charger shown on page 43 will power the camcorder and charge your rechargeable nickel cadmium battery.
To AC Wall Outlet |
|
|
|
| |
|
| Caution: |
|
| When a battery |
|
| is attached to |
Battery Pack |
| the adapter/ |
|
| charger, do not |
|
| turn them |
|
| upside down. |
|
| The battery |
|
| may fall off and |
| REFRESH Button | be damaged or |
| cause injury. | |
POWER Indicator | CHARGE Indicator |
|
Charging and Refreshing Rechargeable Battery
The battery pack provides longer operation time if it is refreshed (completely discharged) before every charging. Refreshing takes approximately
Charge the Battery
1.Plug adapter/charger into an AC outlet
The POWER indicator lights.
2.Align the reference marks on the battery with marks on the adapter/ charger and slide the battery in the direction of the arrow until it locks. The CHARGE indicator lights while battery is charging.
3.Remove the battery when the CHARGE indicator turns off.
Notes: Make sure AC power cord is removed from the outlet when finished.
If the CHARGE indicator flashes rapidly, this may indicate the battery is improperly
installed. Remove it and try again. If the CHARGE indicator still flashes rapidly, it may indicate the battery pack cannot be used.
Refresh the Battery
1.Plug in the adapter/charger and attach the battery.
2.Press REFRESH.
The CHARGE indicator flashes slowly and any remaining charge in the battery is discharged. The CHARGE indicator then stops flashing and the battery pack is recharged.
3.Remove the battery when the CHARGE indicator turns off.
12
