RCA Pro842 Lithium Cell Installation, Replace cell holder in remote until it clicks into place

Powering Your Camcorder

Lithium Cell Installation

The remote’s lithium cell is packed separately. Install it as follows:

Insert Pencil Here	Lithium Cell
	Cell Holder

1.Turn remote over, insert a pencil or paper clip in the small hole, and slide cell holder in the direction of the arrow to remove it.

Cell Holder

Lithium Cell

3.Replace cell holder in remote until it clicks into place.

Notes: Never place anything heavy on top of the remote control or lay it upside-down.

Replace cell when camcorder fails to respond to remote.

Remove cell from remote if it will not be used for a month or more. This will prevent possible damage from cell leakage.

If leakage occurs, wipe up liquid inside compartment and replace cell.

2.Insert the cell in the cell holder so the positive (+) terminal faces up.

Cautions: Lithium cell. Replace only with 3-volt lithium cell – such as CR2025. Use of other cell presents a risk of fire or explosion. Must be disposed of properly. Never handle punctured or leaking cell. May cause burns or personal injury.

Keep out of the hands of children. Can cause death or injury if swallowed. If swallowed, consult a physician immediately for emergency treatment.

The lithium cell used in this device may explode resulting in a fire or chemical burn if mistreated. Do not recharge, disassemble, heat above 212˚F (100˚C), or incinerate.

Never use metallic tweezers to hold the cell, and never short circuit the + and – sides of the cell.

14