AUXILIARY POWER
•115VAC, 42VAC and 24VAC power is available from the two 14-pin amphenols on the rear of the unit. (K1728-2 Construction model of the Invertec V350-PRO (CE) does not have the amphenols) These supplies are intended to supply power for auxiliary equipment like wire feeders and the TIG Module.
•115VAC supply is rated at 2 amps and is protected by a 2.5 amp breaker located by the amphenol.
•42 VAC supply is rated at 5.5 amps and is protected by a 6 amp breaker located by the amphenol.
•24 VAC supply is rated at 5.5 amps and is protected by a 6 amp breaker located by the amphenol.
LIMITATIONS
•The V350-PRO (CE) is not recommended for processes other than those listed.
•The V350-PRO (CE) can only be used with the rec- ommended equipment and options.
RECOMMENDED PROCESSES
Properly equipped, the Invertec V350-PRO (CE) supports GMAW, FCAW, SMAW, GTAW and CAC- A processes for a variety of materials, including mild steel, stainless steel, cored wires, and alu- minum
V350-PRO (CE)
