Dust Collection System (Optional)
Installation
Transport the shipping container to the installation site. Unpack the dust collection system and check for damage. Contact the carrier if damage is found. Open the installation kit (refer to Optional Accessories in the parts listing for installation kits). Install the cover and debris collection drawer if removed. Slip a hose clamp over the
Repeat the procedure to connect the hose to the outlet duct on the grinding machine.
Filter
Check for accumulation of debris. Replace the filter at intervals that you determine are appropriate for your shop environment and machine utilization.
Drawer Seal
Check the drawer seal periodically and replace if damaged or missing. Keep the seal in good condition to help maintain collection system efficiency.
Electrical Connection
Refer to the Dust Collection System Wiring Diagram for wiring information. Connection to electrical power should be made by a qualified electrician. Observe local electrical codes when connecting the machine.
Operation
The dust collection system motor is started by setting the toggle switch on the motor to the ON position. Set the switch to OFF to shut down the dust collection system.
Maintenance
WARNING:
ON/OFF switch on motor at rear of dust collection system
Removable cover – remove for interior cleaning/access to impeller
Second Inlet Duct on this side
28
·MAKE SURE YOU DISCONNECT THE ELECTRI- CAL POWER TO THE DUST COLLECTION SYS- TEM BEFORE PERFORMING MAINTENANCE. FAILURE TO DO SO MAY RESULT IN INJURY TO THE OPERATOR AND/OR MAINTENANCE PERSONNEL.
·DO NOT OPERATE THE DUST COLLECTION SYSTEM WITH THE COVER REMOVED. INJURY TO FINGERS AND HANDS FROM THE FAN BLADES, AND INGESTION OF LOOSE FITTING CLOTHING INTO THE AIR INLET WITH RESULTANT INJURY IS ALSO POSSIBLE.
Cleaning
Outlet filter at rear removes fine debris from outlet air stream
Inlet Duct – Connect 3 inch hose - secure with clamp
Chip Drawer - Pull to Open
Periodically dispose of accumulated chips and debris from the chip drawer. Use a brush to loosen debris from internal surfaces. Use a vacuum cleaner to clean up the loosened debris.