Wilton 4300A, 4200A, 4400A manual Machine Setup, Basic Setup

Page 13

Figure 14: Loosening pulley set screws to allow the adjustment of pulley on arbor shaft.

Machine Setup

Basic Setup

1.Position the machine where it will be located on the shop floor. When positioning the machine, consider the type of work which will be done on it so you allow sufficient room not only for the workpieces, but also for service to the machine.

2.Open the door in the base of the machine and, using the holes in the base as a template, mark the floor for the position of the hold-down bolts.

3.Move the machine to expose the hold-down bolt marks and install anchors for the hold-down bolts.

4.Put the machine back over the hold-down anchors and bolt the machine securely to the shop floor. THIS MUST BE DONE FOR SAFE OPERATION OF THE MACHINE.

5.Establish an electrical service connection to the ma- chine. This will vary according to the model purchased. ALL ELECTRICAL CONNECTIONS SHOULD BE MADE BY A QUALIFIED ELECTRICIAN WHO IS FAMILIAR WITH YOUR STATE AND LOCAL CODES. Many models of these ma- chines make use of high voltages which pose a significant risk of serious injury or DEATH if proper knowledge and precautions are not used. Electrical instructions are in- cluded in the Electrical section of these Machine Setup instructions.

6.Machines with belts are shipped with the belts in slack condition. During the electrical hookup phase of machine setup, the belt will have to be tightened and checked for tracking. See the Belt Replacement section for instructions on this procedure.

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Disc, Belt, and Combination Disc/Belt Sanders Warranty and Service Table of Contents Machine and Manual Overview Disc Sander Belt Sander Disc/Belt Sander General SpecificationsGeneral Machinery Warnings General Machinery CautionsSafety Requirements for Abrasive Sanding Machines Wire SizesGeneral Electrical Cautions Operating Instructions Adjusting the Belt Sander ArmUse of the Miter Gauge Adjusting the Disc Sander TableBelt Replacement MaintenanceInstalling Abrasive Discs Track Mechanism MaintenanceReplacing the V-Belt Rotating the machine casting to remove the disc guard bolts Basic Setup Machine SetupDisc Table Miter Parallelism Adjustment Disc Table Angle AdjustmentDisc Table Gap Adjustment Belt Table Angle Adjustment Belt Table Miter Slot Parallelism AdjustmentAdjusting or Replacing the Platen Electrical Three Phase Electrical Hookup Single Phase Electrical HookupMotor Rotation Voltage ConversionFault Probable cause Suggested remedy TroubleshootingJIC Packages Standard 1 phase and 3 phase machines Replacement PartsExploded View Model 4200A Belt and Disc Sander Assembly Ref # Description Qty Parts Listing Model 4200A Belt and Disc Sander AssemblyExploded View Model 4300A Belt Sander Assembly Parts Listing Model 4300A Belt Sander Exploded View Model 4400A Disc Sander Assembly Parts Listing Model 4400A Disc Sander Assembly Exploded View Base Assembly All Models Maintenance InstallationElectrical Connection OperationDisassembly Exploded View Model 5511885 Dust Collection System Wiring Information Dust Collection System Parts Listing Model 5511885 Dust Collection SystemWMH Tool Group
Top Page Image Contents