Wilton FK350-2SX, FK350-4 manual Controls, Trigger Handle FK350, Control Panel FK350-SX

Controls

Control Panel – FK350

The Control Panel (Figure 4) is located on the front the cabinet stand and consists of the Power and High/Stop/Low switches, described below.

Power Switch – The Power switch has two positions, Off and On.

High/Stop/Low Switch – This switch controls the blade speed. To operate the saw, the power switch must set to on, High or Low must be selected and the Run Trigger depressed.

Figure 4

Trigger Handle – FK350

To operate, the Power switch must be set to on a Hi or Low speed selection made, and the trigger handle, depressed.

Figure 5

Control Panel – FK350-SX

Emergency – Emergency Stop: This turns off the controls, and the machine. When used, it requires that “Control On” button be pushed.

Vise – Open/Close (Manual mode

Mode selection – Select Semi-auto, or Manual mode.

Start – In manual mode, this starts the saw blade. In Semi-auto, this starts the cut-cycle.

Head-UP/ Head-Down – Manual mode only Feed rate – sets feed rate of cut cycle

Figure 6

High/Stop/Low Switch – Refer to Figure 7; located on the front of the cabinet stand; controls the blade speed (Figure 7).

Figure 7

10