Wilton FK350-2SX, FK350-4 manual Operation, FK350-SX

Page 11

Operation

Before using the machine:

‰Check that safety devises (ex., blade guards) are in position and work perfectly and that personal safety requirements are complied with.

‰Check the sharpness of the blade and verify coolant flow.

FK350

1.Make sure the work piece is securely clamped in the vise.

2.Turn the power on (A, Fig. 8).

3.Select the cutting speed (B, Fig. 8).

Figure 8

4.Grip the trigger handle (Figure 5) on the control lever.

5.Start the blade by pressing the micro-switch on the handgrip.

The down stroke speed of the head is controlled manually by the operator. The coolant pump is activated during the time that the head is below the upper limit position.

When the cut is complete:

6.Raise the head.

7.Remove the work piece from the vise using the vise hand wheels.

FK350-SX

To operate machine,

1.Clear the Emergency Stop.

2.Press Control On.

3.Select the desired blade speed.

4.Select Manual or Semi-auto.

Manual Mode – Position material and tighten the vise. Position the head switch to Head-Down until cut is complete. Position the head switch to Head-Up until head retracts to desired height.

Semi-auto Mode – Set the head travel trips to achieve desired head travel extents. Position material in the vise allowing approximately .125" for proper air vise operation, and then press cycle start. After the cycle is complete, the vise opens for material repositioning.

Note: The coolant pump is activated while the motor is running.

Figure 9

11

Image 11
Contents Cold Saw Warranty Warranty and ServiceTable of Contents Page Page Cutting Capacity All Models SpecificationsIntroduction FK350 Features Features Anchoring and handling the machine InstallationElectrical Connections Unpacking the machineControl Panel FK350-SX ControlsControl Panel FK350 Trigger Handle FK350FK350-SX OperationFK350 Depth Stop FK350 Miter AdjustmentTrip Adjustment FX350-SX Maintenance Coolant System LubricationCutting and Feeding Speed General CharacteristicsBlade Selection Determining Proper Tooth PitchTeeth Shape Blade StructureTypes of Blades Page Troubleshooting Blade and Cutting Problems TroubleshootingParts Troubleshooting Machine Fault & Operating ProblemsOrdering Replacement Parts Index No. Part No Description Size Qty Head Assembly FK350 & FK350-SXHead Assembly FK350 & FK350-SX Power Feed Assembly FK350-SX Power Feed Assembly FK350-SX Stock Stop Assembly Stand Assembly FK350 Stand Assembly FK350-SX Stand Assembly FK350-SX TS-223A911 Base Assembly FK350Base Assembly FK350 Base Assembly FK350-SX Base Assembly FK350-SX Manual Vise Assembly FK350 Manual Vise Assembly FK350 Power Vise Assembly FK350-SX File TS-1521021 Guard Assembly FK350 & FK350-SXGuard Assembly FK350, FK350-2SX In-Feed Table Assembly TS-1502071 Out-Feed TablePneumatic Drawing FK350-SX Wiring Diagram FK350 Wiring Diagram FK350-SX Page Page WMH Tool Group