Wilton FK350-4, FK350-2SX manual Installation, Electrical Connections, Unpacking the machine

Page 9

Installation

Unpacking the machine

Do not handle the packed machine using slings.

To install the machine, first remove the packing, paying particular attention not to cut any electric wires or hydraulic hoses. Lift using straps (Figure 3).

Figure 3

Anchoring and handling the machine

The base of the machine must be anchored to the floor by two lag bolts or studs properly anchored into concrete.

Electrical Connections

All electrical connections must be done by a qualified electrician. All adjustments or repairs must

be done with the machine disconnected from the power source, unplugged. Failure to comply may result in serious injury!

FK350-2 and FK350-2SX are rated at 220V. FK350-4 and FK350-4SX are rated at 440V.

These machines not supplied with a plug. Use a plug and outlet rated at least 20amps. The circuit for the machine should also be protected by at least a 20 amp circuit breaker or fuse.

Make sure that the blade turns in the correct direction. If it does not, simply reverse two of the phase wires on the supply input.

The sawing machine is now ready for use.

9

Image 9
Contents Cold Saw Warranty Warranty and ServiceTable of Contents Page Page Specifications IntroductionCutting Capacity All Models FK350 Features Features Electrical Connections InstallationUnpacking the machine Anchoring and handling the machineControl Panel FK350 ControlsTrigger Handle FK350 Control Panel FK350-SXOperation FK350FK350-SX Miter Adjustment Trip Adjustment FX350-SXDepth Stop FK350 Maintenance Coolant System LubricationBlade Selection General CharacteristicsDetermining Proper Tooth Pitch Cutting and Feeding SpeedBlade Structure Types of BladesTeeth Shape Page Troubleshooting Blade and Cutting Problems TroubleshootingTroubleshooting Machine Fault & Operating Problems Ordering Replacement PartsParts Index No. Part No Description Size Qty Head Assembly FK350 & FK350-SXHead Assembly FK350 & FK350-SX Power Feed Assembly FK350-SX Power Feed Assembly FK350-SX Stock Stop Assembly Stand Assembly FK350 Stand Assembly FK350-SX Stand Assembly FK350-SX TS-223A911 Base Assembly FK350Base Assembly FK350 Base Assembly FK350-SX Base Assembly FK350-SX Manual Vise Assembly FK350 Manual Vise Assembly FK350 Power Vise Assembly FK350-SX File TS-1521021 Guard Assembly FK350 & FK350-SXGuard Assembly FK350, FK350-2SX In-Feed Table Assembly TS-1502071 Out-Feed TablePneumatic Drawing FK350-SX Wiring Diagram FK350 Wiring Diagram FK350-SX Page Page WMH Tool Group