Makita LF1000 dimensions Frame Section, Hex nut M10, Right Frame and Left Frame

P 15/ 30

Repair

[3]DISASSEMBLY/ASSEMBLY

[3]-8. Frame Section

DISASSEMBLING

1)After removing Switch box, place the Frame section as illustrated in Fig. 37, and remove four Square pipes by unscrewing eight M8x20 Hex socket head bolts.

2)Place the Frame section as illustrated in Fig. 38. Then, by removing four M10 Hex nuts from Pipe 32 complete (with Makita mark label) and Pipe 32 (without Makita mark label), separate right Frame from left Frame.

Fig. 37 Fig. 38

Hex socket head bolt M8x20 (8 pcs)

Pipe 32

Square pipe (4 pcs)

Pipe 32 complete

Flat washer 10

Spring washer 10

Hex nut M10

(4 pcs each)

3)From each of *right and *left Frames, remove Pipe 32 complete (Pipe 32) and Screw M10. (Fig. 39)

4)Caps can be removed from Frame by tapping the joint of Cap and Frame with slotted screwdriver. (Fig. 40) Note: Do not reuse Caps removed from Frame because it is deformed or damaged when removed.

Fig. 39

Frame, right

(See Note below.)

Pipe 32

Screw M10

Frame, left Pipe 32 complete

(See Note below.)

Note:

This end of Screw M10 is screwed in the threaded hole

of Frame. Therefore, unscrew when removing from Frame.

Fig. 40

Cap

Cap

*Right Frame and Left Frame;

Are exactly the same in size and shape.

However, some different parts such as Switch box or Lock lever are assembled to them.

For convenience, therefore, we call the one on operator's right hand "Right Frame" and the other "Left Frame".