Makita LF1000 dimensions Table Section

P 12/ 30

Repair

[3]DISASSEMBLY/ASSEMBLY

[3]-7. Table Section

DISASSEMBLING

When disassembling the Table section, Arm complete has to be separated from Sub arm. However, it is not necessary to separate the Blade case section from Arm complete.

1)Remove Power supply cord from Strain relieves on Frame. However, it is not necessary to remove from the Strain relief on Connecting rod.

2)Remove Pan head screw M4x10 and Lever 100. After unscrewing Hex nut M10-17, remove Spacer and Thrust needle gauge 1022. (Fig. 28)

3)Unscrew Hex lock nut M10-17. Then remove Indication plate from Sub arm by unscrewing Pan head screw M4x10. (Fig. 29)

4)By removing Hex bolt M10, Arm complete can be separated from Sub arm. (Fig. 30)

Fig. 28

	Blade case
Thrust needle gauge 1022
	Arm complete
Spacer
Hex nut M10-17
Lever 100	Sub arm
Pan head screw M4x10
	Turn table complete

Fig. 29

Indication plate

Hex lock nut

M10-17

Pan head screw M4x10

Fig. 30

Hex bolt M10

5)Remove Screw M6x25 and Pin 5. And remove Hex socket head set screw M10x12, Compression spring 6 and Steel ball 7.9. Then turn over the Table section in the direction of arrow. (Fig. 31)

Fig. 31

Hex socket head set screw M10x12

*Compression spring 6

*Steel ball 7.9

The small parts designated with an asterisk can be removed using a bar or screwdriver magnetized with No.1R288.

Sub arm	Screw M6x25
	* Pin 5

Guide fence

Turn table complete

Table complete