Makita Essential Guide for Oil Capacity and Troubleshooting of MAC5200

Page 13

OWNERS MANUAL

ROUTINE MAINTENANCE SCHEDULE

ROUTINE MAINTENANCE SCHEDULE

1)Drain water from the air tank, any moisture separators or transformers.

2)Check for any unusual noise and/or vibration.

3)Manually check all safety valves to make sure they are operating properly.

4)Inspect air filter, replace if necessary.

5)Inspect air lines and fittings for leaks; correct as necessary.

Each year of operation or if a problem is suspected:

Check condition of air compressor pump intake and exhaust valves.

Check condition of check valve. Replace if damaged or worn out.

Filling with oil:

1)Remove the oil filler plug.

2)Slowly pour the proper oil into the pump crankcase.

3)Always keep oil level in the middle of the sight glass.

Changing the oil:

Note: Every 300 hours or 3 months, whichever comes first.

1)Remove the oil drain plug. Allow oil to drain completely.

2)Replace the oil drain plug (The use of a sealing compound or Teflon tape to avoid leakage is recommended.)

3)Refill with the recommended oil to the proper level.

COLD WEATHER CONDITIONS

	Ambient Temperatures at	SAE	ISO
	Point of operation	Viscosity	Viscosity
	-16°C TO 0°C (3.2°F - 32°F)	SAE 10W	ISO 32

	1°C TO 26°C (33.8°F - 78.8°F)	SAE 20W	ISO 68

	ABOVE 27°C (80.6°F)	SAE 30W	ISO 100

MAKITA - MAC700 / MAC2400 / MAC5200

13

Image 13

Contents Model no MAC700 MAC2400 MAC5200Table of Contents Risk of Unsafe Safety InstructionsOperation Risk of Air Tank AccessoriesBursting Risk of AttachmentsRisk of Explosion or Risk of Electric ShockFire Risk to BreathingCompressed Air Risk fromMoving Parts Risk of BurnGlossary CUT-OUT Pressure When you turn onDuty Cycle General InformationStorage On Receipt InspectionDescription of Operation Description of Operation Installation and BREAK-IN ProceduresLocation of the AIR Compressor Lubrication and OILInitial Start Up Procedure Installation and BREAK-IN Procedures ... Cont’dExtension Cords 25’ 50’ 100’ 150’Daily Start-Up Checklist Operating ProceduresPiping Grounding InstructionMaintenance Operating ProceduresWhen you are finished Each year of operation or if a problem is suspected Routine Maintenance ScheduleCold Weather Conditions Filling with oilAir Filter Inspection and Replacement Service InstructionsUnits with External Brass Check Valve Replacement MotorDo not Over Tighten Troubleshooting GuideProblem Cause Correction Problem Cause Correction California Makita Retain this Portion for Your RecordsMakita MAC700 / MAC2400 / MAC5200 Warranty Policy Makita Limited ONE Year WarrantyMakita Corporation Your answers to the following questions are appreciated Mail this PortionMakita U.S.A., Inc