1
1.Bit
2.Bit holder
002114 When not using the driver bit, keep it in the bit holders. Bits 45 mm
2
OPERATION
002132
Screwdriving operation
Place the point of the driver bit in the screw head and apply pressure to the tool. Start the tool slowly and then increase the speed gradually. Release the switch trigger as soon as the clutch cuts in.
NOTE:
•Make sure that the driver bit is inserted straight in the screw head, or the screw and/or bit may be damaged.
•When driving wood screws, predrill pilot holes to make driving easier and to prevent splitting of the workpiece. See the chart.
Nominal diameter of | Recommended size | ||
wood screw (mm) | of pilot hole (mm) | ||
3.1 (1/8”) | 2.0 | - 2.2 (5/64” - 3/32”) | |
3.5 (9/64”) | 2.2 | - 2.5 (3/32” - 3/32”) | |
3.8 (5/32”) | 2.5 | - 2.8 (3/32” - 7/64”) | |
4.5 (11/64”) | 2.9 | - 3.2 (7/64” - 1/8”) | |
4.8 (3/16”) | 3.1 | - 3.4 (1/8” - 9/64”) | |
5.1 (13/64”) | 3.3 | - 3.6 | (1/8” - 9/64”) |
5.5 (7/32”) | 3.7 | - 3.9 | (9/64” - 5/32”) |
5.8 (7/32”) | 4.0 | - 4.2 | (5/32” - 11/64”) |
6.1 (15/64”) | 4.2 | - 4.4 | (11/64” - 11/64”) |
•If the tool is operated continuously until the battery cartridge has discharged, allow the tool to rest for 15 minutes before proceeding with a fresh battery.
12