Makita 6213D instruction manual Additional Safety Rules for Charger Battery Cartridge, 100 150

Page 6

c.That wire size is at least as large as the one specified in the table below.

Table 1: RECOMMENDED MINIMUM AWG SIZE FOR EXTENSION CORDS FOR BATTERY CHARGERS

Length of Cord (Feet)

25

50

100

150

 

 

 

 

 

AWG Size of Cord

18

18

18

16

 

 

 

 

 

9.Do not operate charger with damaged cord or plug - replace them immediately.

10.Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way; take it to a qualified serviceman.

11.Do not disassemble charger or battery cartridge; take it to a qualified serviceman when service or repair is required, Incor- rect reassembly may result in a risk of electric shock or fire.

12.To reduce risk of electric shock, unplug charger from outlet before attempting any maintenance or cleaning. Turning off con- trols will not reduce this risk.

13.The battery charger is not intended for use by young children or infirm persons without supervision.

14.Young children should be supervised to ensure that they do not play with the bat- tery charger.

15.If operating time has become excessively shorter, stop operating immediately. It may result in a risk of overheating, possi- ble burns and even an explosion.

16.If electrolyte gets into your eyes, rinse them out with clear water and seek medi- cal attention right away. It may result in loss of your eyesight.

ADDITIONAL SAFETY RULES FOR CHARGER &

BATTERY CARTRIDGE

1.Do not charge Battery Cartridge when temperature is BELOW 10°C (50°F) or ABOVE 40°C (104°F).

2.Do not attempt to use a step-up trans- former, an engine generator or DC power receptacle.

3.Do not allow anything to cover or clog the charger vents.

4.Always cover the battery terminals with the battery cover when the battery car- tridge is not used.

5.Do not short the battery cartridge:

(1)Do not touch the terminals with any conductive material.

(2)Avoid storing battery cartridge in a container with other metal objects such as nails, coins, etc.

(3)Do not expose battery cartridge to water or rain.

A battery short can cause a large current flow, overheating, possible burns and even a breakdown.

6.Do not store the tool and Battery Car- tridge in locations where the temperature may reach or exceed 50°C (122°F).

6

Image 6
Contents Cordless Driver Drill Specifications General Safety RulesWork Area Specific Safety Rules ServiceSymbols Additional Safety Rules for Charger Battery Cartridge 100 150Page Installing or removing battery cartridge Functional DescriptionCharging Trickle charge Maintenance charge Electric brake Switch actionReversing switch action Speed changeAssembly Adjusting the fastening torqueInstalling or removing driver bit or drill bit Operation Screwdriving operationMaintenance Drilling operationRecycling the Battery Replacing carbon brushesAccessories Memo Makita U.S.A., Inc Mail this Portion Factory Service Centers Makita Limited ONE Year Warranty