ATTACHING THE MOTOR TO THE MOTOR BRACKET
1.Position the motor (A) Fig. 5 on the motor brackets (B). Align the holes in the motor with the holes in the motor bracket.
2.Insert a
3.Thread a
NOTE:
4.Repeat this process for the three remaining holes in the motor and motor bracket.
5.Place the stand upright (Fig. 6).
Fig. 5
Fig. 6
A
B | B |
ATTACHING THE TOP PLATE TO THE STAND
NOTE: If your machine comes with an LVC starter box, refer to the enclosed supplemental instruction sheet for mounting that equipment. Then follow these instructions:
1.Place the top plate (A) Fig. 7 on the top of the stand
(B).
NOTE: Place the switch cord (F) Fig. 7 through the slotted hole (G) in the top plate (A) and insert a plastic bushing (H) in the slotted hole (G).
2.Align the eight holes in the stand and top (6 in the top and 2 on the side).
4.Insert a
5.Repeat this process for the seven remaining holes.
NOTE: Make sure the door opening is at least 13" wide before you tighten the screws.
A
B
Fig. 7
H 
F G
10