EnGenius Technologies 28-248 instruction manual Mounting AN LVC BOX to the Cabinet

MOUNTING AN LVC BOX TO THE CABINET

SINGLE PHASE (MODELS 28-248F & 28-348F) & THREE PHASE (MODELS 28-248G & 28-248G)

NOTE: The single phase LVC box comes with a connected power cord. The three-phase LVC box does NOT come with a power cord.

NOTE: Attach both the single phase model and the three-phase model according to the following instructions.

1.Loosen, but do not remove the three screws (A) Fig. 1 on the back of the LVC box.

A

Fig. 7A

2.Insert the power cord (single phase only) through the hole (C) Fig. 2 from inside the cabinet.

3.Insert the three screws on the back of the LVC box

(A) Fig. 1 into the three holes (B) Fig. 2 on the inside of the cabinet. Push down on the box to engage the screws in the slots to secure the box.

4.Tighten the three screws (A) Fig. 3 from the outside of the cabinet to hold the LVC box in place.

B

C

Fig. 7B

A

Fig. 7C

11