EnGenius Technologies 28-248 instruction manual Carton Contents

Page 8

CARTON CONTENTS

UNPACKING AND CLEANING

Carefully unpack the machine and all loose items from the shipping container(s). Remove the protective coating from all unpainted surfaces. This coating may be removed with a soft cloth moistened with kerosene (do not use acetone, gasoline or lacquer thinner for this purpose). After cleaning, cover the unpainted surfaces with a good quality household floor paste wax.

1.Remove the cardboard box from the packing skid (A) Fig. 1.

2.Use a 3/8" wrench to remove the two bolts (B) Fig. 1 that attach the motor to the packing skid.

3.Remove the bolts that attach the stand (C) Fig. 2 and the saw (D) to the the packing skid (A) with a 1/2" wrench.

B

A

Fig. A

Fig. C

1

1

3

22

4

35

4

5

1.Saw

2.Stand

3.Dust Chute

4.Top Plate

5.Stand Door

NOTE: LVC box and hardware are included with certain models.

D		C


		A

Fig. B

K	6		7		8
E	6		7		8
E
Y

9

10

11 12

13

14

Fig. D

6.Motor and key (A)

7.Table

8.Belt

9.On/Off Switch

10Motor Bracket (2)

11.Dust Spout

12.Blade

13.Table Insert

14.Motor Pulley

8

Image 8

Contents Wood Cutting Band Saw Table of Contents Important Safety InstructionsSafety Guidelines Definitions California PropositionGeneral Safety Rules Important Safety Instructions Additional Specific Safety Rules Failure to Follow These Rules MAY Result in Serious InjuryGrounding Instructions Power ConnectionsMotor Specifications Extension Cords Functional DescriptionForeword Carton Contents Assembly Assembly Tools RequiredAssembly Time Estimate Attaching the Motor Bracket to the StandAttaching the Motor to the Motor Bracket Attaching the TOP Plate to the StandMounting AN LVC BOX to the Cabinet Band SAW Used Without a Dust Collector Installing the Dust ChuteBand SAW Used with a Dust Collector Attaching the Door to the Stand Attaching the Belt to the SAW Pulley and the Motor Pulley Attaching the SAW to the StandAttaching the Motor Pulley Attaching the Table to the SAW Installing the Table Insert Attaching the Blade to the SAWAttaching the on / OFF Switch to the Stand Tilting the Table OperationStarting and Stopping the SAW Adjusting the 90 Degree Table Stop Setting the Adjustable StopsAdjusting the Blade Tension Disconnect the machine from the power sourceVertical Adjustment of the Upper Blade Guide Assembly Tracking the BladeAdjusting the Upper Blade Guides and Blade Support Bearing Adjusting Lower Blade Guides and Blade Support BearingTroubleshooting Guide Cutting CurvesTrouble Band SAW does not Come UP to Speed Maintenance Keep Machine CleanBand SAW Blades Failure to StartReplacement Parts Service and Repairs ServiceAccessories Warranty Two Year Limited New Product WarrantyDelta Machinery