Friedrich CP08 operation manual ScrewType B Sill Support

6.The cabinet should be installed with a very slight tilt (about 1/2") downward toward the outside

(See Fig. 5).

Adjust the bolt and the nut of Sill Support for balancing the cabinet.

7.Attach the cabinet to the window stool by driving

the screws [Type B: Length 16mm (5/8 inch) and below.] through the front angle into window stool.

8.Pull each Frame Curtain to each window sash track, and repeat step 2.

9.Attach each Frame Curtain to the window sash using screws (Type C). (See Fig. 6)

CAUTION: Do not drill a hole in the bottom pan. The unit is designed to operate with approximately 1/2" of water in bottom of pan.

There is no need to add water if the pan is dry.

10. Slide the unit into the cabinet. (See Fig. 7)

CAUTION: For security purpose, reinstall the 2 screws (Type A) at cabinet's side, that were removed in step 1 on page 10.

11.Cut the Foam-Strip to the proper length (window width) and insert between the upper window sash and the lower window sash. (See Fig. 8)

15

Screw(Type B) 6

Sill Support	2	ENGLISH
	" / 2
	About1

Sash track

		Front Angle
Sill Support		Screw(Type B) 6
	2	Fig. 5

Type C 7

Fig. 6

Screw(Type A)

Power cord	Screw	Fig. 7
	(Type A)

Foam-Strip 8

Fig. 8

13