Friedrich 49, 24, 60, 18 Inspect and Clean INDOOR-AIR Coil, Inspect OUTDOOR-AIR Intake and Exhaust

Page 19

INSPECT AND CLEAN INDOOR-AIR COIL

Eventually, minor amounts of lint and dirt may pass through the filter and collect on the indoor-air coil. These minor accumulations can be carefully vacuumed away with a brush attachment on a vacuum cleaner. Care must be taken to avoid bending the aluminum fins on the coil. Bent fins should be straightened using a special fin tool available from most HVAC service technicians.

INSPECT OUTDOOR-AIR INTAKE AND EXHAUST

The unit’s outdoor-air intake and outdoor-air exhaust paths must remain clear. Check the OA exhaust frequently. Keep it free of all debris, snow, or ice. The OA intake should also be kept free of obstructions. Blocking the OA exhaust or OA intake opening will reduce the efficiency of your unit, could damage it, and void your warranty.

INSPECT AND CLEAN CONDENSATE DRAIN

The condensate drain must be routed to a suitable drainage area. Check the unit condensate drain periodically. Keep it free of anything that may block or impede the flow of condensate water. If there is any accumulation of foreign matter in the drain pipe, it should be removed and cleaned. The entire drain line must be protected from freezing.

19

Image 19
Contents Installation Table of Contents Unpack and Inspect Unit Safety ConsiderationsSupplies Needed for Installation General Recommendations DOS and DontsVERT-I-PAKMODEL Identification Guide Section I General SpecificationsCondensate Drain Exit Above Floor Section III Installation Indoor and Outdoor AIR Requirements Unit ConfigurationOutdoor Air System VPBWP4 8/14 Wall Plenum VPBWP3 8/14 Wall PlenumVPBWP6 8/14 Wall Plenum VPBWP5 8/14 Wall PlenumDucted Condenser Air Typical Ducted Outside Air ConfigurationOutdoor Fan Performance Indoor Fan Performance Indoor-Air Conditioned Supply Air SystemReturn Air Options Cooling and Fan Electrical Grounding Power SupplyThermostat Wiring Thermostat Mounting and Wiring A. Thermostat LocationThermostat Mounting and Wiring Wire Thermostat Cable to Unit Terminal StripTest Run Installation Final ChecklistImportant Facts Identifying Your SystemOperating the VERT-I-PAK Thermostat Operation Heat Mode OperationHeating Cycle Cooling CycleDefrost Cycle Replace AIR Filter Performing Routine MaintenanceInspect and Clean Condensate Drain Inspect and Clean INDOOR-AIR CoilInspect OUTDOOR-AIR Intake and Exhaust Use Factory-Certified Parts