Anton/Bauer LOGIC Series owner manual

Page 5

IMPORTANT

The Logic Series DIGITAL battery has been specifically designed to be charged with the Anton/Bauer Logic Series InterActive Chargers ONLY (any InterActive 2000 PowerCharger, MP-4D, Quad, Dual, MP-2, Q2, ABC-800H or CPS-2). These Chargers were developed in anticipation of the DIGITAL battery and include the proper DIGITAL interface circuitry.

Since all programming is contained on one single EPROM chip, earlier Logic Series Charger models already in the field may not contain the latest DIGITAL software. The DIGITAL batteries will simply require a new EPROM chip to set up complete communication.

Replacement EPROM chips are available by contacting the Anton/Bauer Customer Support Group at 1-800-541-1667 or 203-929- 1100 or fax 203-929-9935.

THE DIGITAL BATTERY CAN NOT BE USED WITH STANDARD ANTON/BAUER LIFESAVER CHARGERS (LSQ4, LSFC, LSQC, etc.) OR NON-ANTON/BAUER CHARGERS. Call the Anton/Bauer Customer Support Group if there is any question of charger compatibility.

- 1 -

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Digital Battery System Page Table of Contents Page Page Introduction FeaturesPage High Voltage Design Digital Trimpac ApplicationsDigital Propac High Rate Discharge Charging with Logic Series Chargers OVER-DISCHARGED Batteries Hours Minutes Liquid Crystal Display LCDPage RealTime Display Indications Preventative Maintenance Guidelines for Optimum Performance Maximum Life Page Service Specifications Logic Series Digital Battery Limited Warranty
Top Page Image Contents