Color profile: Disabled Composite Default screen
IMPORTANT
You can change the receiver volume only when you are on a call.
TIP
If the base loses power while the handset is off the base, the digital code may be erased. If this happens, the handset won’t function. You must reestablish the connection between the handset
and base.
ADJUSTING RINGER CONTROLS
▼Ringer tone and volume
With no call in progress, press ringer. The phone has 3 ringer tones with 2 volume levels - one soft and one loud. Each time you press ringer,
the ringer tone changes. Each time you press volume, the ringer volume changes.
▼ Receiver volume
While on a call, press volume.
The phone has two receiver volume levels - one soft and one loud. Each time you press volume,
the receiver volume changes.
AUTOMATIC DIGITAL CODE SECURITY
To avoid unauthorized calls on your phone, a digital code was added to the EXV 958 phone. Only the handset and base share this digital code. The code will automatically set when you first use the phone.
▼To change the digital code:
1)Place the handset on the base.
2)Press page on the base.
The handset will beep for about 15 seconds.
3)When the beeping stops, briefly remove the handset and then return it to the base.
The status LED blinks to indicate that the digital security code is set to one of the more than 65,000 codes.
▼To establish communication between the handset and base:
1)Restore power to the base.
2)Place the handset on the base. The status LED blinks to indicate that the digital security code is set.
8
I:...exv958final.vp
Fri Jun 19 20:15:08 1998