Jump Starting Instructions

SUGGESTED AC RECHARGE TIMES

After a single jump start:	1 hour
After multiple jump starts:	12 hours or overnight
After using as portable power:	24-36 hours

Charging using the supplied 12 Volt Male-Male Extension Cord. This alternative charging method may be used when access to an AC outlet is unavailable.

1.Start the vehicle’s engine.

2.Plug one end of the 12 Volt Male-Male Extension Cord into the Jump-N-Carry12 Volt outlet and the other end into the vehicle’s 12 Volt power port.

3.Charge the unit based on the suggested recharge times shown in the following table.

SUGGESTED 12 VOLT RECHARGE TIMES

After jump starting:	20 minuntes
After using as portable power:	2 hours
After high discharge conditions:	5 hours

Note: DO NOT OVERCHARGE! You must frequently monitor the charging process to ensure the unit is not overcharged. Overcharging will damage your Jump-N-Carry.

Note: For optimum performance, do not store your Jump-N-Carrybelow 50° when using as a jump starter. NEVER charge or jump start a frozen battery.

1.Use in a well ventilated area.

2.Shield eyes. Always wear protective eyewear when working near batteries.

3.Review this instruction manual and the instruction/safety manual provided by the manufacturer of the vehicle being jump started.

4.Turn ignition off before making cable connections.

5.Clamp the positive (red +) clamp to the positive terminal on the vehicle battery (for negative ground system), or an alternate vehicle starting point as recommended by vehicle manufacturer.

6.Clamp the negative (black –) clamp to the vehicle ground (non-moving metal part, such as the vehicle frame).

7.Make sure the cables are not in the path of moving engine parts (belts, fans, etc.).

8.Stay clear of batteries while jump starting.

9.Start the vehicle (turn on the vehicle ignition).

Note: If the vehicle doesn’t start within 6 seconds, let the Jump-N-Carrycool for 3 minutes before attempting to start the vehicle again or you may damage the Jump-N-Carry.

10.When the vehicle is started, disconnect the negative (–) battery clamp from the vehicle frame and return it to its holster.

11.Disconnect the positive (+) clamp and return it to it’s holster.