Sterling Power Products DAI-1500C-24xx, DAI-3000C-24xx user manual Diagram of the different mode

Page 21

-18-

F.1 Diagram of the different mode

Indicates an off LED

Indicates a orange blinking LED Indicates a lit green LED

All the functions are enabled. This is factory setting.

The inverter ins disabled. Only the Bypass switch and charger will work normally.

Charger and Bypass switch are disabled. The inverter will work continuously even if there is a correct AC voltage at the input.

Inverter and charger are both disabled. Only the Bypass switch function is enabled in input and frequency is OK.

Image 21

Contents Sterling Content INVERTER： Operating instructions General InformationSterling Warranty Terms and Conditions WarrantySpecial Precautions Bypass switch Basic schematicIntroduction InverterRemote control Battery chargerBattery connections Solar charge regulator opetionalParallel Connection Series Connection Parallel-Series Connection Installation LocationRear Panel Connection to battery Cabling / wiringConnection to the AC Output Connection to the AC InputConnection to Remote control unit optional Connect the Solar modules Solar in +Connection to Aux1 & AUX2 Operating Front Panel Display And Operating DescriptionPush buttons LED Indicator Power Dspl Power saving function Fn02 OverloadOverheating Over Temp Battery Condition Disabling Functions Fn05 Diagram of the different mode Charger Information Input current repartition Power sharing Fn06Charging Cycle Set the charging current Fn07Solar charge regulator Transfer systemTemperature sensor Remote control unitAuxiliary Contacts Maximum Contact load -230Vac / 5Amp-30Vdc/7AmpProgramming Aux Contacts AUX1, AUX2 PrincipleExample Auxiliary contact as generator starter Maintenance Inverter Section Specifications