Sterling Power Products DAI-3000C-12xx, DAI-3000C-24xx, DAI-1500C-24xx, DAI-1500C-12xx Maintenance

Page 26

-23-

M. Maintenance

Periodic maintenance is important to avoid potential problems. Every six months disconnect all power in and out from the system. Thoroughly clean and check all battery connections within the battery bank and to the unit . Ensure all connections to the unit are tight. Ensure the vents at the top and bottom of the unit are clear of any debris, such as mud wasps, severe dust build ups etc.

Other than this, you should enjoy years of trouble free operation form your unit.

Image 26
Contents Sterling Content INVERTER: General Information Operating instructionsWarranty Sterling Warranty Terms and ConditionsSpecial Precautions Introduction Basic schematicBypass switch InverterBattery connections Battery chargerRemote control Solar charge regulator opetionalParallel Connection Series Connection Parallel-Series Connection Rear Panel InstallationLocation Connection to the AC Output Cabling / wiringConnection to battery Connection to the AC InputConnection to Aux1 & AUX2 Connection to Remote control unit optionalConnect the Solar modules Solar in + Push buttons OperatingFront Panel Display And Operating Description LED Indicator Power Dspl Overheating Over Temp Power saving function Fn02Overload Battery Condition Disabling Functions Fn05 Diagram of the different mode Charging Cycle Input current repartition Power sharing Fn06Charger Information Set the charging current Fn07Transfer system Solar charge regulatorAuxiliary Contacts Remote control unitTemperature sensor Maximum Contact load -230Vac / 5Amp-30Vdc/7AmpExample Auxiliary contact as generator starter Programming Aux Contacts AUX1, AUX2Principle Maintenance Specifications Inverter Section