Panasonic SC-RT50 warranty Guide

Page 45

Radio

 

Page

 

Noise is heard.

pThis is being caused by weak signal reception.

 

 

Sound is distorted.

When listening to FM radio, try the following operations.

 

 

“TUNED” is flashing or doesn’t

–Adjust the position of the FM antenna.

—

 

light.

–Use an FM outdoor antenna.

34

 

“ST” is flashing or doesn’t light

–Press [FM MODE] to set to “MONO”.

34

 

during FM broadcasts.

When listening to AM radio, try the following operations.

—

guide

 

–Adjust the position of the AM antenna.

 

–Press [FM MODE] to select between “BP1” and “BP4” that receives good reception.

34

are erased.

remove the AC power supply cords until “BYE” disappears from the unit’s display.

—

Troubleshooting

A beat sound is heard.

pTurn the television off or separate it from the unit.

 

A low hum is heard during AM

pSeparate the antenna from other cables and cords.

—

 

broadcasts.

 

 

 

The radio cannot be tuned in.

pTurn off nearby televisions, video cassette recorders, satellite receivers and computers.

—

 

 

 

 

 

All programmed radio presets

pRadio and sound field system settings are stored to memory after pressing [ ]. Do not

—

 

Returns to the original setting

 

 

 

even after making changes to the

 

 

 

sound field system settings.

 

 

 

Sound

 

 

 

 

 

 

 

No sound.

pCheck the connections and settings.

2–11

 

Low volume.

 

(Setup Guide),

 

Distorted sound.

 

39

 

Cannot hear the desired audio

pPress [AUDIO] to select the audio.

17

 

type.

pSome multi-channel DVD-Audio will prevent down-mixing of all or part of their contents if this

49

 

 

is the manufacturer’s intention.

 

 

 

In the following situations, these DVD-Audio discs will not output audio correctly (Front two

 

 

 

channels only, etc. will output audio).

41

 

 

–When using headphones.

 

 

–When audio is output through the television speakers.

—

 

 

pTurn the volume up.

—

 

 

pTurn muting off.

36

 

 

pSwitch off the unit, determine and correct the cause, then switch the unit on.

—

 

 

Causes include:

 

 

 

–Shorting (bare wires touching) of positive and negative speaker wires.

 

 

 

–Using speakers with an impedance lower than that rated for this unit.

 

 

 

–Straining of the speakers through excessive volume or power.

 

 

 

–Using the unit in a hot environment without proper ventilation.

35, 36

 

 

pThe factory settings for the “H. Bass” and Subwoofer levels are optimized for 5.1 channel

 

 

movie playback. If the bass seems too heavy during 2-channel disc playback, etc. change the

 

 

 

settings.

—

 

 

p When “R MUSICP” is selected, you cannot set anything other than “Equalizer (EQ)” or “H.

 

 

Bass” to change the sound quality. Also, when using headphones, you cannot set anything

 

 

 

other than “Equalizer (EQ)” or “Surround Music”.

41

 

 

pIf the audio is distorted when “F MUSICP” or “R MUSICP” is selected, turn the volume down

 

 

on the connected external device.

—

 

 

pWhen audio playback is output through multi-channel, “Sound Field Control (SFC)” cannot be

 

 

set.

—

 

 

pThe sound effects will not work when audio is output from the HDMI AV OUT terminal.

 

 

pAudio may not be heard when more than 4 devices are connected with HDMI cables. Reduce

—

 

 

the number of connected devices.

—

 

 

pDepending on the connected equipment, the sound may be distorted if this unit is connected

 

 

with an HDMI cable.

 

 

Cannot switch audio.

pYou cannot change the audio type when DVD-R, DVD-R DL, DVD-RW (DVD-Video format),

—

 

 

+R, +R DL or +RW is in the disc tray.

39

 

 

pYou cannot change the audio type when playing DVD-R, DVD-R DL, DVD-RW (DVD-Video

 

 

format), +R, +R DL or +RW. [You can select “Main” or “SAP” in “Multi-channel TV Sound

 

 

 

(MTS)” in the Setup menu before recording.]

—

 

 

pThere are discs where audio cannot be changed because of how the disc was created.

 

 

 

 

 

Humming heard during play.

pAn AC power supply cord or fluorescent light is near the main unit. Keep other appliances

—

 

 

and cords away from the main unit.

 

 

Operation

 

 

 

Cannot operate the television.

The remote control doesn’t work.

pPress [TV] to switch the remote control to operate the television.

pChange manufacturer code. Some televisions cannot be operated even if you change the code.

pPress [THEATER] to switch the remote control to operate this unit. pThe remote control and main unit are using different codes.

Change the code on the remote control. Press and hold [ENTER] and the indicated number button at the same time for more than 2 seconds.

pThe batteries are depleted. Replace them with new ones.

pYou are not pointing the remote control at the main unit’s remote control signal sensor during operation.

pColored glass may obstruct the signal reception/transmission.

pDon’t place the signal sensor in direct sunlight or in areas that may be subject to sunlight exposure.

pIt may be necessary to set the code on the remote control again after changing the batteries.

pIt may be necessary to set the manufacturer code again after changing the batteries.

—

15

(Setup Guide)

—

15

(Setup Guide)

4

4

—

—

15

(Setup Guide)

15

(Setup Guide)

RQT8655

45

Page 44 Page 46
Image 45
Page 44 Page 46
Contents Model No. SC-RT50 Warranty can be found onRQT8655-1P InfoPReorient or relocate the receiving antenna FCC NoteListening caution Table of contentsAccessories Accessories/The remote control informationRemote control information BatteriesControl reference guide Remote controlMain unit Unit’s displayDiscs you can use for recording and play Disc and card informationDVD-R DVD-R DL*1 DVD-RW +RWDiscs that cannot be played Play-only discsCards you can use on this unit Structure of folders displayed by this unitInserting/Removing SD card Disc and card handlingUnit care Power on link Automatic input switchingPower off link Control with Hdmi Hdavi ControlImportant notes for recording When opening the tray without disc finalization When finalizing the discRecording modes and approximate recording times Disc Insertion/EjectionPress 9 CH to select the channel Recording television programsPress q REC to start recording To pause recordingFlexible Recording To specify a time to stop recording -One Touch RecordingPlaying while you are recording Selecting audio to recordPress Schedule Scheduled recordingPress , to select New Scheduled Recording and press Enter Press to move through the items Change the items withCheck, change or delete a program Cancel scheduled recording that has already begunRelease program from recording StandbyPlaying discs Selecting recorded titles to play -Direct NavigatorStatus messages Operations during play Press Direct Navigator Using menus to play still pictures JPEG/TIFFPress , , , to select the album and press Enter Press , , , to select the stillUseful functions during still picture play Press , to select the track and press Enter Using menus to play MP3Press , to select a group and press Enter DisplayPress Display Using on-screen menusPlay MenusEditing titles/chapters WWhen the Album View screen is displayedEditing titles/chapters and playing chapters Press , , , to select the titleChapter operations Title operationsCreating playlists Creating, editing and playing playlistsPlaylist operations Editing and playing playlists/chaptersWWhen the Title View screen is displayed Editing still picturesPress , , , to select the album to edit Album and picture operations Copying still pictures Copying using the copying listPress Functions Press To select Start Copying and press EnterTo edit the copying list Copying settingsCopying from a video cassette recorder Manual recordingDV camcorder recording DV Camcorder Rec Deleting a title or a still picture during play Entering text Delete NavigatorDVD and Card Management Setting the protection-Disc ProtectionDeleting all titles and playlists -Delete All Titles Providing a disc with a name -Disc NameCreating Top Menu Create DVD Top Menu Enabling discs to be played on other equipment-FinalizePress Select Create DVD Top Menu and press Enter Press To select Yes Press Enter To select StartPreset tuning Manual tuningRadio Press and hold EnterChanging the sound quality Sound effectSpeaker level adjustments Adjusting the subwoofer levelDolby Digital and DTS Muting the soundSummary of settings Changing the unit’s settingsCommon procedures Press SetupChanging the unit’s settings Audio Changing the unit’s settingsDisplay ScreenChanging the delay time Speaker SettingAdjusting the speaker levels Front L Center Front RConnecting other audio equipment Using other useful functionsUsing headphones Using the Music PortMessages On the televisionOn the unit’s display Messages / Frequently asked questions Frequently asked questionsTroubleshooting guide Guide Function does not work Equipment settings Troubleshooting guideDuring disc or card operation Or DVD-RW VR format discsShorten Title operation Start point Cannot delete chapters Troubleshooting guideAvailable recording space Card Scheduled recording beganProduct information Product ServiceModel Number SC-RT50Glossary Specifications Panasonic Audio Products Limited Warranty Limited WarrantyCorporation of North America Index
Top Page Image Contents