Hitachi C 10FR instruction manual Push Stick

Page 23

— 23 —

PUSH STICK

Make from 1/2” or 3/4”

wood or thickness less than width of material to be cut.

Cut off here to push 1/4” wood.

Cut off here to push 1/2” wood.

Notch to help prevent hand from slipping.

1/2” Squares.

Optional

hanging hole.

CAUTION!

Use only good

strong wood or plywood.

Use a jigsaw or

bandsaw to cut out.

Image 23
Contents 10FR Hitachi Authorized Service Centers YES Product SpecificationsMotor SAW Check for Damaged or Loose Parts Power Tool SafetyTable SAW Safety Guidelines for Extension Cords Electrical Requirements and SafetyPower Supply Requirements Extension RequirementsCarton Contents Accessories and AttachmentsTools Needed for Assembly Unpacking Your Table SAW Front of Table Saw Know Your Table SAWAssembly and Adjustments Keeping the Area Clean RIP Fence Fig. G Installing and Changing the Blade Fig. H, I, JInstalling Table Side Extensions Fig. N Blade Guard Assembly Fig. K, L, MRIP Fence Adjustment Fig. Q Installing Table Side EXTENSIONS- contd Fig. OInstalling Rear Table Extension Fig. P Adjusting Rear Table ExtensionBlade Tilt Pointer RIP Fence Indicator Adjustment Fig. QAdjusting the 90 and 45 Positive Stops Fig. Q-1, Q-2, Q-3 StopBlade Parallel to the Miter Gauge Groove Fig. R, S Additional blade adjustments Fig. SBasic SAW Operations OperationRipping Fig. W Cutting OperationsCompound Miter Crosscutting Fig. AA Bevel RippingRipping Small Pieces Bevel Crosscutting Fig. ZPutting it together Mitering Fig. BBAuxiliary Fence Fig. CC-1 Making the base Making the sideLubrication MaintenanceMaintaining Your Table SAW Symptom Possible Causes Corrective Action Troubleshooting GuidePush Stick JOB Site Table SAW Model NO. C10FR Parts ListParts List for Schematic a JOB Site Table SAW Model NO. C10FR Model NO. C10FR JOB Site Table SAWPage Hitachi Koki Canada Co