Work Piece and Work Area Set Up
1.Designate a work area that is clean and
2.Locate the Compressor on a flat level surface to ensure proper pump lubrication and to prevent damage to the unit. Keep at least 12” of space around the unit to allow air circulation.
3.Route the power cord from the compressor to the grounded wall outlet, along a safe path without creating a tripping hazard or exposing the power cord to possible damage.
Assembly/Mounting
Tank (70)
Nut (24) | Hex Nut (65) | |
| ||
Foot Pad (67) | ||
Washer (68) | Wheel (63) | |
Sleeve (64a) | ||
| ||
Figure 2 Screw (69) | Washer (64b) | |
Bolt (64) |
1.Attach the Wheels (63) to the Tank (70), using the Bolts (64), Washers (64b), Sleeves (64a), and Hex Nuts (65). Attach the Foot Pads (67) to the bottom of the Tank (70) using the Screws (69) and Washers (68).
Handle (72)
Bolts (71)
Figure 3 | Tank (70) |
|
2.Slide the Handle (72) into the two slots on the top of the Tank (70) and secure in place with four Bolts (71).
Cylinder Head (7)
Air Filter
(6)
Figure 4
3.Thread the Air Filter (6) onto the side of the Cylinder Head (7).
4.Break in the new Air Compressor as follows:
a.Make sure the Power Lever is OFF and the unit is unplugged. Insert a male coupler (sold separately) into the female Quick Coupler (76) and fully open all regulators and valves.
b. Plug in the Power Cord.
SKU 67847 | For technical questions, please call | Page 9 |