Harbor Freight Tools 67847 operating instructions Grounding

Page 6

RECOMMENDED MINIMUM WIRE GAUGE FOR EXTENSION CORDS

(120 VOLT)

NAMEPLATE

EXTENSION CORD

AMPERES

 

LENGTH

 

(at full load)

25’

50’

100’

150’

10.1 – 12

16

16

14

12

12.1 – 16

14

12

Do not use.

TABLE A

 

 

 

 

a. Make sure your extension cord is in good condition.

b. Be sure to use an extension cord which is heavy enough to carry the current your product will draw. An undersized cord will cause a drop in line voltage resulting in loss of power and overheating. Table A shows the correct size to use depending on cord length and nameplate ampere rating. If in doubt, use the next heavier gauge. The smaller the gauge number, the heavier the cord.

17.Industrial applications must follow OSHA guidelines.

18.Maintain labels and nameplates on the compressor. These carry important safety information. If unreadable or missing, contact Harbor Freight Tools for a replacement.

19.This product is not a toy. Keep it out of reach of children.

20.Operate unit on level surface. Check oil level daily and fill to marked level if needed.

21.People with pacemakers should consult their physician(s) before use. Electromagnetic fields in close proximity to heart pacemaker could

cause pacemaker interference or pacemaker failure.

22.WARNING: The brass components of this product contain lead, a chemical known to the State of California to cause birth defects (or other reproductive harm). (California Health & Safety code § 25249.5, et seq.)

23.The warnings, precautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.

Save these instructions.

Grounding

To prevent electric shock

and death from incorrect grounding wire connection: Check with a qualified electrician if you are in doubt as to whether the outlet is properly grounded. Do not modify the power cord plug provided with the compressor. Never remove the grounding prong from the plug. Do not use the compressor if the power cord or plug is damaged. If damaged, have it repaired by a service facility before use. If the plug will not

Page 6

For technical questions, please call 1-800-444-3353.

SKU 67847

Image 6
Contents For technical questions or replacement parts, please call ModelContents General Compressor Safety Save This ManualMatching outlets will reduce risk of electric shock Air Compressor Safety Warnings 25’ 50’ 100’ 150’Grounding Symbology 120 V~ 3-Prong Plug and OutletInstructions for putting into use SpecificationsUnpacking FunctionsWork Piece and Work Area Set Up Assembly/MountingSample Air Line Setup Checking the OilGeneral Operating Instructions Cold Weather OperationSKU For technical questions, please call Emergency Depressurization Automatic Shut off SystemMaintenance Servicing Cleaning, Maintenance, LubricationMaintenance Schedule Oil MaintenanceAir Filter Maintenance Draining Moisture from the TankProblem Possible Causes Likely Solutions Cord, or eliminate extension cord. See Recommended Parts List Part Description QtyAssembly Diagram Limited 1 year / 90 day Warranty Mission Oaks Blvd. PO Box 6009 Camarillo, CA 93011 800