Harbor Freight Tools 67847 Air Compressor Safety Warnings, 25’ 50’ 100’ 150’

Page 5

5.Service

a.Have your compressor serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the compressor is maintained.

Air Compressor Safety Warnings

1.Risk of fire or explosion - Do not spray flammable liquid in a confined area or towards a hot surface. Spray area must be well-ventilated. Do not smoke while spraying or spray where spark or flame is present. Arcing parts - Keep compressor at least 20 feet away from explosive vapors, such as when spraying with a spray gun.

2.Risk of bursting - Do not adjust regulator higher than maximum stated pressure of attachment.

3.Risk of injury - Do not direct air stream at people or animals.

4.To reduce the risk of electric shock, do not expose to rain. Store indoors.

5.Wear ANSI-approved safety goggles during use.

6.Do not use to supply breathing air.

7.Do not use the air hose to move the compressor.

8.Drain Tank daily and after use. Internal rust causes tank failure and explosion.

9.Add correct amount of compressor oil before first use and every use. Operating with the incorrect amount of oil causes permanent damage and voids warranty. To prevent damage, do not use with

overfilled or low oil. Slowly fill to full line, wait 2 minutes and fill back up to full line. Compressor has small passages that will fill slowly.

10.Do not remove the Pressure Switch (54) cover or adjust the internal components.

11.Do not use the air hose to move the compressor.

12.Compressor head gets hot during operation. Do not touch it or allow children nearby during or immediately following operation.

13.Release the pressure in the storage tank before moving.

14.The use of accessories or attachments not recommended by the manufacturer may result in a risk of injury to persons.

15.All air line components, including hoses, pipe, connectors, filters, etc., must be rated for a minimum working pressure of 125 PSI, or 150% of the maximum system pressure, whichever is greater.

16.USE OF AN EXTENSION CORD IS NOT RECOMMENDED. If you choose to use an extension cord, use the following guidelines:

RECOMMENDED MINIMUM WIRE GAUGE FOR EXTENSION CORDS

(120 VOLT)

NAMEPLATE

EXTENSION CORD

AMPERES

 

LENGTH

 

(at full load)

25’

50’

100’

150’

0 – 6

18

16

16

14

6.1 – 10

18

16

14

12

TABLE A

 

 

 

 

SKU 67847

For technical questions, please call 1-800-444-3353.

Page 5

Image 5
Contents Model For technical questions or replacement parts, please callContents Save This Manual General Compressor SafetyMatching outlets will reduce risk of electric shock 25’ 50’ 100’ 150’ Air Compressor Safety WarningsGrounding 120 V~ 3-Prong Plug and Outlet SymbologyUnpacking SpecificationsInstructions for putting into use FunctionsAssembly/Mounting Work Piece and Work Area Set UpChecking the Oil Sample Air Line SetupSKU For technical questions, please call General Operating InstructionsCold Weather Operation Automatic Shut off System Emergency DepressurizationCleaning, Maintenance, Lubrication Maintenance ServicingOil Maintenance Maintenance ScheduleDraining Moisture from the Tank Air Filter MaintenanceProblem Possible Causes Likely Solutions Cord, or eliminate extension cord. See Recommended Part Description Qty Parts ListAssembly Diagram Mission Oaks Blvd. PO Box 6009 Camarillo, CA 93011 800 Limited 1 year / 90 day Warranty