Harbor Freight Tools 93380 Assembly Instructions, Selecting a Proper Location For The Table Saw

Page 14

Selecting A Proper Location For The Table Saw:

1.The location selected for the Table Saw must be level, dry, well lighted, and have room enough to allow movement around the Saw with long pieces of woodstock.

2.Once located, set a carpenter’s level on the Main Table (115) of the Table Saw and level the machine from front to back and side to side. If necessary, use shims (not included) under the corners of the Saw.

ASSEMBLY INSTRUCTIONS

NOTE:

For additional information regarding the parts listed in the

following pages, refer to the Assembly Diagrams on pages 32, 33, and 34.

1. CAUTION! Always make sure the Power Switch (137) of the Table Saw is in its “OFF” position and the tool is unplugged from its electrical outlet prior to assembling the tool, adding any accessories, or making adjustments to the tool. Because of the weight of the product, assemble and set up should be performed by at least 2 people.

To Install The Left And Right Wings:

1.Attach the Left Wing (113) and Right Wing (114) to the Main Table (115), using three Bolts (111) and three Flat Washers (112) for each Wing. Finger tighten only. (See Figure G.)

2.Align the fronts of the Left Wing (113) and Right Wing (114) with the top of the Main Table (115) directly above the front Bolts (111), and flush with the edge of the Main Table. Then, firmly tighten the front Bolts. (See Figure G.)

3.Align the rears of the Left Wing (113) and Right Wing (114) with the top of the Main Table (115) directly above the front Bolts (111), and flush with the edge of the Main Table. Then, firmly tighten the front Bolts. (See Figure G.)

BOLTS (111)

FLAT WASHERS (112)

FIGURE G

SKU 93380

For technical questions, please call 1-800-444-3353.

Page 14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Table SAW For technical questions, please callSave this Manual Product SpecificationsGeneral Safety Rules Work AreaElectrical Safety Personal SafetyTool USE and Care Specific Safety Rules ServiceIndustrial applications must follow Osha guidelines Never attempt to cut more than one workpiece at a timeSKU For technical questions, please call SKU For technical questions, please call Grounding Grounded Tools Tools with Three Prong PlugsSee Figure B, next Extension CordsSee Figure a See Figure B Symbology Figure BUnpacking Table SAW FeaturesPallet Disassembly SET-UP InstructionsSee Figures D and E Motor Brace DisassemblyClean Up Selecting a Proper Location For The Table Saw Assembly InstructionsTo Install The Left And Right Wings To Install The Clean Out Door And Dust Hood To Attach The Front And Rear Fence RailsSee Figure J To Install The Saw BladeTo Attach The Hand Wheels See Figure K SKU For technical questions, please callTo Install The Table Insert Figure KTo Install The Blade Guard Assembly Figure LSee Figure O, next SKU For technical questions, please call To Attach The Power Switch AssemblySee Figure N See Figure Q AdjustmentsTo Adjust The Splitter And Blade Guard Assembly See Figure R Figure RTo Adjust The 45 Degree And 90 Degree Positive Stops Figure TTo Adjust The Saw Blade Parallelism Figure USee Figure Basic Operation For Using The Rip Fence AssemblyOperating Instructions RIP Fence Assy Basic Operation For Using The Miter Gauge Assembly Figure YINSPECTION, MAINTENANCE, and Cleaning See FigureYSee Figure Z, next Please Read the Following Carefully Figure ZTroubleshooting Parts List Part Description QtyAssembly Diagram Parts List and Assembly Diagram Description17B Power Switch Schematic
Top Page Image Contents