Figure G

3.NOTE: The back side of the Front Rail (part #7H) has two slots. Slide the upper slot of the Front Rail over the Square Head Bolts (part #10H). (See Figures F, G, and Assy. Diagram H.)

(FRONT EDGE)

10” TABLE SAW/EXTENSION

TABLES (#5H)

SQUARE HEAD BOLT (#10H)

(UPPER SLOT)

HEX NUT (#13H)

FRONT RAIL (#7H)

WASHER (#12H)

SEMI-CIRCLE HEAD SCREW (#2E)

SWITCH PLATE	(LOWER SLOT)
(#3E)

SQUARE

NUT(#4E)

4.To align the Front Rail (part #7H), match the 7-1/8" mark on the right scale with the right edge of the 10" Table Saw Base (part #1G). (See Figure H, and Assy. Diagram H.)

5.Wrench tighten all five Square Head Bolts (part #10H). (See Figures F, G, and Assy. Diagrams G, and H.)

6.Secure the Right/Front End Cap (part #8H) and Left/Front End Cap (part #9H) to the Front Rail (part #7H), using one Tapping Screw (part #1H) on each end. (See Assy. Diagram H.)

To Attach The Rear Rail:

1.NOTE: The procedure for attaching the Rear Rail (part #3H) to the 10" Table Saw is similar to that of attaching the Front Rail (part#7H) to the Table Saw. (See “To Attach The Front Rail” section, Figures I, J, and Assy. Diagram H.)

2.Insert five Square Head Bolts (part #10H) through the mounting holes in the rear edges of the 10" Table Saw and Extension Tables (part #5H). Allow the bolt heads to extend out about 1/2". (See Figures I, J, and Assy. Diagram H.)

SKU 46813

PAGE 13