ASSEMBLY INSTRUCTIONS
NOTE: For additional references to the parts listed below, refer to the Assembly Diagrams on pages 29 through 37 of this manual.
WARNING! PRIOR TO PERFORMING ANY ASSEMBLY PROCEDURES, MAKE SURE THE 10" TABLE SAW IS DISCONNECTED FROM ITS ELECTRICAL POWER SOURCE.
To Mount The 10" Table Saw On A Workbench:
1.NOTE: If the 10" Table Saw is mounted onto a workbench instead of the Leg Assembly, the workbench surface must have an opening for sawdust to fall through. This opening must be as large as the opening in the bottom of the 10" Table Saw Base (part #1G). A minimum height of 36" from the top of the Base to the floor is recommended. (See Figure B, and Assy. Diagram G.)
2.With assistance, set the 10" Table Saw in a desired location on the workbench. NOTE: Make sure the workbench provides a flat, level, sturdy surface capable of supporting the weight of the 10" Table Saw, tool accessories, and workpieces.
3.Use the four 5/16" mounting holes located at the bottom of the Base (part #1G)) as a template, and mark the two points at which four holes will be drilled through the workbench. Then, temporarily set the 10" Table Saw aside.
(See Figure B, and Assy. Diagram G.)
4.With a drill and a 5/16” drill bit (not provided), drill four mounting holes downward through the top of the workbench.
5.Align the four mounting holes at the Base (part #1G) of the 10" Table Saw with the four previously drilled holes in the workbench. Then secure the 10" Table Saw to the workbench, using four 5/16” bolts of appropriate length, two lock washers, and two nuts (not provided).
To Assemble The Leg Stand:
1.NOTE: Temporarily finger tighten all hardware mentioned in this section until the Leg Stand is fully assembled.
2.Attach one Long Leg Brace (part #10B) to the lower mounting holes in two Legs (part #4B), using one Carriage Bolt (part #5B), one Washer (part #3B), and one Hex Nut (part #2B) for each Long Leg Brace. Repeat the assembly procedure for the remaining one Long Leg Brace and two Legs.
(See Figure B, and Assy. Diagram B.)
SKU 46813 | PAGE 9 |