Figure M

To Assemble And Attach The Bevel And Height Handles To The Base:

1.Insert one Screw (part #6G) each through a Bevel Handle and Height Handle (part #5G). Tighten each Screw into a Hand Wheel Assembly (part #4G). Then, attach an End Cap (part #7G) to each of the two Handles.

(See Figures B, M, and Assy. Diagram G.)

2.Align one Handle Assembly (part #4G) with the Height Adjustment Rod (part #33-I) that extends from the front of the Base (part #1G). Match the flat spots on the Height Adjustment Rod and inside the Hand Wheel Assembly. Insert a Socket Head Screw (part #8G) and Washer (part #9G) in the center of the Hand Wheel Assembly and tighten. (See Figures B, M, and Assy. Diagrams G, and I.)

3.Align the remaining Handle Assembly (part #4G) with the Threaded Rod (part #22-I) that extends from the right side of the Base (part #1G). Match the flat spots on the Threaded Rod and inside the Hand Wheel Assembly. Insert a Socket Head Screw (part #8G) and Washer (part #9G) in the center of the Hand Wheel Assembly and tighten.

(See Figures B, M, and Assy. Diagrams G, and I.)

BEVEL LOCK (#19-I)

BEVEL HANDLE (#5G)

HEIGHT HANDLE (#5G)

To Attach The Motor:

1.Loosen the Bevel Lock Handle (part #19-I). Turn the Bevel Handle (part #5G) counterclockwise until it stops. Then, retighten the Bevel Lock Handle.

(See Figure M, and Assy. Diagrams I, and G.)

2.Align the four mounting holes in the Motor Bracket (part #7F) with the four mounting holes in the Motor Mounting Plate (part #50-I).

(See Figure N, and Assy. Diagrams F, and I.)

SKU 46813

PAGE 17