Figure J

10” TABLE SAW/EXTENSION TABLES (#5H)

(REAR EDGES)

REAR RAIL (#3H)

HEX NUT

(#13H)

SLOT

WASHER (#12H)

SQUARE HEAD

BOLT (#10H)

5.Wrench tighten all five Square Head Bolts (part #10H). (See Figures I, J, and Assy. Diagram H.)

To Attach The Rip Fence And Miter Gauge:

1.Hook the Lock Block (part #7C) under the Rear Rail (part #3H). Then, lower the front of the Rip Fence (part #10C) into the groove on the Front Rail (part #7H). (See Figures K, L, and Assy. Diagrams C, and H.)

2.NOTE: The Rip Fence (part #10C) can be removed and reinstalled on the left side of the 10" Table Saw. In this case, the Rip Fence Scale Indicator (part #20C) can be repositioned on the left side of the Rip Fence by removing the Semi-Circle Head Screw (part #22C) and Star Washer (part #21C). Then reposition the Rip Fence Scale Indicator, and secure it with the Semi-Circle Head Screw and Star Washer. (See Figures K, L, and Assy. Diagrams C, and Assy. Diagram H.)

3.NOTE: To attach the Miter Gauge Assembly (parts #1A through 12A), simply slide the Miter Gauge Rod (part #10A) into the right or left slot (nearest the Saw Blade opening, on the Saw Table (part #17H).

(See Figure B, and Assy. Diagrams A, and H.)

SKU 46813

PAGE 15