Setting Battery Voltages For Li-Po Battery Pack

LiPo CHARGE 3.0A C=3000mAh

LiFe CHARGE 3.0A C=3000mAh

Lilo CHARGE 3 C=3000mAh 10.8Vp

Setting Battery Voltages For Li-Po Battery Pack

Select the correct total battery voltage to be charged with the INC & DEC buttons – 3.7V, 7.4V, 11.1V, 14.8V and 18.5V

[Vpack].

Setting Battery Voltages For Li-Fe Battery Pack

Select the correct total battery voltage to be charged with the INC & DEC buttons – 3.3V, 6.6V, 9.9V, 13.2V and 16.5V [Vpack].

Setting Charge Current

Always set the capacity first. When the capacity has been set, the current will automatically show an equivalent of 1C. For instance, a 3000mAh battery will initially show 3A. This can be varied up to 2C (6A max) or down to 0.1A using the INC & DEC buttons. That current may be further limited automatically to a lower value if

the charging power exceeds 50W (Amps x Volts).

IMPORTANT NOTE

For safety purposes, this charger is designed to automatically deliver a 1C charge rate to batteries of Li-Ion, Li-Po or Li-Fe, based on the user selected battery capacity unless over-ridden only for batteries designed to accept 2C charging. Example: Li-Po cell of 1500mAh capacity : 1C = 1500mAh ( = 1.5A ) charge current.

Lithium Type

Setting Battery Type

Choose the desired battery type (Li-Ion, Li-Po or Li-Fe ) with the INC & DEC buttons. Press the ENTER button to confirm the setting.

IMPORTANT NOTE

The maximum voltage for Li-Ion is 4.1V per cell, 4.2V per cell for Li-Po batteries and 3.7V per cell for Li-Fe batteries. Therefore, it is extremely important to choose the correct Lithium battery type to be charged, as each Lithium battery has a different voltage level. If not, it may cause very serious damage to the batteries and

increase the risk of a fire!

BALANCER CON. NOT CONNECTED

BALANCER CON.

CONNECTED

The left screen will be shown if the Lithium charge or discharge starts without the balancing cable connected to the balancing port of the charger.

The left screen will be shown if the Lithium charge or discharge starts with the balancing cable connected to the balancing port of

the charger.