OPERATION
•When the charger is connected to the power source the charger will show the battery mode that was last used.
•If the battery TYPE button is briefly pressed, the present battery type (NiCd, NiMH, Lithium, or Pb ) will flash. While the existing battery type is flashing, every time the battery TYPE button is pressed, the following modes are shown in order:
NiCd CHARGE BATT TYPE
NiMH CHARGE BATT TYPE
C=3.0AC=3.0A
LiIo CHARGE | 3.0A | BATT TYPE |
| ||
C=3000mAh | 10.8Vp |
|
|
|
|
Pb CHARGE | BATT TYPE |
|
C=3.0A 12V Pack |
|
|
|
|
|
PROGRAMMING
NiCd Mode
BATT TYPE | CHARGE | INC |
| NiCd |
| C=3.0A |
| DEC | volt = 0mV/cell |
| ENTER |
|
| ENTER |
INC | DEC |
NiCd CHARGE
C=3
START
BATTERY CHECK
WAIT PLEASE....
CHG 0:00 00000 NC+3.00A 5.200V
INC | DEC |
NiCd 
NiCd CHARGE C=3
NiCd 
Setting Charge Current
Adjust the desired charge current, which ranges from 0.1A to 6.0A with the INC & DEC buttons. Press the ENTER button to confirm the setting.
Setting Delta Peak Sensitivity
Set the Delta Peak Sensitivity from 5mV to 25mV per cell with the INC & DEC buttons and press the ENTER button to confirm the setting.
6