INPUT BATTERY VOLTAGE ERROR
NO BATTERY
OUTPUT BATTERY REVERSE POLARITY
OUTPUT CIRCUIT PROBLEM
CHECK THE BATT. OPEN CIRCUIT
CHECK THE BATT. OVER VOLTAGE
CHECK THE BATT. LOW VOLTAGE
BALANCER VOLTAGE IS TOO HIGH
BALANCER VOLTAGE IS TOO LOW
DON’T CHARGE LiXX
WITH THIS MODE
ERROR MESSAGES
Input voltage is below 11.0V or exceeds 15V.
Battery is not connected to the charger’s output banana sockets.
Battery is connected to the output banana sockets in reverse.
The circuit of the charger has a problem.
Battery has become disconnected during an operation.
Wrong voltage is set while charging Lithium or Pb batteries.
Wrong voltage is set, or batteries are over discharged, while charging Lithium or Pb batteries.
Voltage per cell is too high during balancing. The pack may be faulty.
Battery cells are
If the charger attempts to start charging with settings for NiCd/MH, or Pb batteries while there is a balancing cable connected to the balancing port of the charger. This helps prevent charging Lithium batteries in the wrong charge mode.
12