Operation, Starting and Stopping Machine

2.Place the inner flange (I) Fig. 1, onto the motor arbor as shown in Fig. 13

3.Place the blade (J) Fig. 1, onto the motor arbor. NOTE: Make sure the blade is placed on the arbor with the arrow on the blade facing counter-clockwise, as shown in Fig. 14.

4.Place the outer flange (I) Fig. 1, onto the motor as shown in Fig. 15.

5.Tighten the arbor nut (O) Fig. 1, onto the arbor Fig. 16 using the 2 wrenches provided (M,N) Fig. 1. NOTE: Wrench (M) Fig. 1, is used to hold the arbor in place while wrench (N) Fig. 1, is used to tighten the arbor nut onto the arbor.

6.Close blade cover and tighten blade cover knob (A) Fig. 12.

7.Attach the rip guide (P) Fig. 1 to the cutting tray by loosening the locking knob and placing the rip guide onto the front of the cutting tray and tighten the locking knob Fig 17.

Fig. 17

Fig. 13

Fig. 14

Fig. 15

Fig. 16

OPERATION

STARTING AND STOPPING MACHINE

Make sure switch is OFF and power circuit voltage is the same as that shown on the specification plate.