WATER PUMP
The flow rate dial (A) Fig. 22B, should be set on the maximum setting.
RIP GUIDE
The rip guide (A) Fig. 22A is used to make precision cuts. Loosen knob (B), position the rip guide on the cutting tray scale to the amount of tile to be cut off and then tighten knob. Hold the tile against the rip guide and the cutting tray and proceed to cut the tile as discussed in the section
“OPERATING TILE SAW.”
A 
Fig. 22B
MAINTENANCE
KEEP TOOL CLEAN
Periodically blow out all air passages with dry compressed air. All plastic parts should be cleaned with a soft damp cloth. NEVER use solvents to clean plastic parts. They could possibly dissolve or otherwise damage the material.
Wear ANSI Z87.1 safety glasses while using compressed air.
A
Fig. 23
FAILURE TO START
The cutting tray can be detached for cleaning purposes by pulling the locking pin (A) Fig. 23 out, so that the tray can slide off the rail. Change water in water tray daily. Do not leave water in water tray overnight.
Do not cut tile without using the tile cutting tray.
Should your tool fail to start, check to make sure the prongs on the cord plug are making good contact in the outlet. Also, check for blown fuses or open circuit breakers in the line.
14