Porter-Cable 1500, 895736 instruction manual Replacement Parts, Motor

There are certain applications for which this tool was designed. Porter-Cable strongly recommends that this tool NOT be modified and/or used for any application other than for which it was designed. If you have any questions relative to its application DO NOT use the tool until you have written Porter-Cable and we have advised you.

	Technical Service Manager
	Porter-Cable Corporation
	4825 Highway 45 North
SYMBOL	Jackson, TN 38305
	DEFINITION
V	........................ volts
A	........................ amperes
Hz	........................ hertz
W	........................ watts
kW	........................ kilowatts
µF	........................ microfarads
l	........................ liters
kg	........................ kilograms
N/cm2	........................ newtons per square centimeter
Pa	........................ pascals
h	........................ hours
min	........................ minutes
s	........................ seconds
	........................ alternating current
3	........................ three-phase alternating current
3N	........................ three-phase alternating current with neutral
	........................ direct current
n0	........................ no load speed
	........................ alternating or direct current
	........................ Class II Construction
	........................ splash-proof construction
	........................ watertight construction
…/min	........................ revolutions or reciprocation per minute
	SAVE THESE INSTRUCTIONS

REPLACEMENT PARTS

When servicing use only identical replacement parts.

MOTOR

Many Porter-Cable tools will operate on either D.C., or single phase 25 to 60 cycle A.C. current and voltage within plus or minus 5 percent of that shown on the specification plate on the tool. Several models, however, are designed for A.C. current only. Refer to the specification plate on your tool for proper voltage and current rating.

7