MAINTENANCE
Customer Responsibilities
| Before | Daily or | Every | Every | Every | Every |
|
| each | after each | 8 | 40 | 100 | 160 | Yearly |
| use | use | hours | hours | hours | hours |
|
|
|
|
|
|
|
|
|
Check Safety Valve | ● |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Drain Tank |
| ● |
|
|
|
|
|
Oil Leaks |
|
| ● |
|
|
|
|
|
|
|
|
|
|
|
|
Check Oil |
|
| ● |
|
|
|
|
Change Oil |
|
|
|
| ● |
|
|
Unusual Noise and/or |
|
| ● |
|
|
|
|
Vibration |
|
|
|
|
|
| |
|
|
|
|
|
|
| |
Air Filter |
|
|
| ●1 |
|
|
|
Drive Belt |
|
|
|
|
|
|
|
Condition |
|
|
| ● |
|
|
|
Motor Pulley/Flywheel |
|
|
|
|
| ● |
|
alignment |
|
|
|
|
|
| |
|
|
|
|
|
|
| |
Air compressor pump |
|
|
|
|
|
| ● |
intake and exhaust |
|
|
|
|
|
| |
valves |
|
|
|
|
|
|
|
Inspect air lines and fit- |
| ● |
|
|
|
|
|
tings for leaks |
|
|
|
|
|
| |
|
|
|
|
|
|
| |
|
|
|
|
|
|
| |
1- more frequent in dusty or humid conditions |
|
|
|
|
| ||
|
|
|
|
|
|
|
|
Unit cycles automatically when power is on. When performing maintenance, you may be
exposed to voltage sources, compressed air, or moving parts. Personal injuries can occur. Before performing any maintenance or repair, disconnect power source from the compressor and bleed off all air pressure.
To ensure efficient operation and longer life of the air compressor outfit, a routine maintenance schedule should be prepared and followed. The following routine maintenance schedule is geared to an outfit in a normal working environment oper- ating on a daily basis. If necessary, the schedule should be modified to suit the conditions under which your compressor is used. The modifications will depend upon the hours of operation and the working environment. Compressor outfits in an extremely dirty and/or hostile environment will require a greater frequency of all maintenance checks.
NOTE: See “Operation” section for the location of controls.
To Check Safety Valve
If the safety valve does not work properly, over- pressurization may occur, causing air tank rup-
ture or an explosion.
1.Before starting compressor, pull the ring on the safety valve to make sure that the safety valve operates freely. If the valve is stuck or does not operate smoothly, it must be replaced with the same type of valve.
13 - ENG | D23269 |