Porter-Cable CPFAC2600P instruction manual How to Stop, Before First Start-up

Page 12

Air Compressor Pump (not shown): Compresses air into the air tank. Working air is not available until the compressor has raised the air tank pressure above that required at the air outlet.

Check Valve: When the air compressor is

 

operating, the check valve is "open”, allowing

Check Valve

compressed air to enter the air tank. When the

 

air compressor reaches "cut-out” pressure, the

 

check valve "closes”, allowing air pressure to

 

remain inside the air tank.

 

How to Use Your Unit

How to Stop:

1.Set the On/Auto/Off lever to "OFF".

Before First Start-up

Break-in Procedure

Serious damage may result if the following break-in instructions are not closely followed.

This procedure is required before the air compressor is put into service and when the check valve or a complete compressor pump has been replaced.

1.Make sure the On/Auto/Off lever is in the "OFF" position.

NOTE: Pull coupler back until it clicks to

 

 

prevent air from escaping through the

Quick

quick connect.

Connect

2. Plug the power cord into the correct

 

branch circuit receptacle. (Refer to

 

Voltage and Circuit Protection

On/Auto/

paragraph in the Installation section

Off Lever

of this manual.)

 

3. Open the drain valve fully

Regulator

(counterclockwise) to permit air to

 

escape and prevent air pressure

 

build up in the air tank during the break-in period.

4.Move the On/Auto/Off lever to "ON/AUTO" position. The compressor will start.

5.Run the compressor for 15 minutes. Make sure the drain valve is open and there is minimal air pressure build-up in tank.

6.After 15 minutes, close the drain valve (clockwise). The air receiver will fill to "cut-out" pressure and the motor will stop.

The compressor is now ready for use.

D27856

12 - ENG

Image 12
Contents Pancake Compressor Safety Guidelines Definitions Important Safety InstructionsResult in death or serious injury Minor or moderate injury Death or serious injuryHazard Risk of Explosion or FireTo Spark Risk of Bursting Risk from Flying ObjectsRisk of Electrical Shock Risk to BreathingRisk of Burns Risk from Moving PartsRisk of Falling Hazard Risk of Unsafe Operation Jury or Death to YOU or OthersGlossary Model no CPFAC2600PInstallation Location of the Air CompressorGrounding Instructions Improper Grounding can Result in ElectricalExtension Cords Voltage and Circuit ProtectionKnow Your Air Compressor Description of OperationHow to Stop Before First Start-upHow to Start Before Each Start-UpTo Check Safety Valve Customer ResponsibilitiesTo Drain Tank To Replace or Clean Check Valve CheckValve Hose ClampUsing an adjustable wrench remove To Replace RegulatorUnplug unit Outlet pressure gauge and quick connect From the regulatorStorage Limited Warranty This Warranty does not CoverManual de Compresores De tipo plano Instrucciones Definiciones DE Normas DE Seguridad Importantes Instrucciones DE SeguridadModeradas Lesiones seriasInstrucciones Importantes DE Seguridad Guarde Estas InstruccionesPeligro Riesgo DE Explosión O Incendio Peligro Riesgo DE Explosión Peligro Riesgo DE Objetos Arrojados POR EL AirePeligro Peligro Riesgo DE InhalaciónRiesgo DE Descarga Eléctrica Peligro Riesgo DE Quemaduras Peligro Riesgo DE Partes MóvilesPeligro Riesgo DE Caida Riesgo DE Operación Insegura Glosario NO. DE Modelo CPFAC2600PCómo Preparar LA Unidad Ubicación del compresor de aireInstrucciones Para Conectar a Tierra Cables de extensión eléctrica Protección del voltaje y del circuitoOperación Conozca su compresor de aireDescripción de operaciones Cómo utilizar su unidad Cómo detenerlaAntes de poner en marcha Válvula reguladoraAntes de cada puesta en marcha Cómo poner en marchaMantenimiento Responsabilidades del clienteCómo verificar la válvula de seguridad Cómo drenar el tanqueServicio Y Ajustes Para reemplazar o limpiar la válvula reguladoraPara reemplazar el regulador Regulador Conector rápidoNiple FlechaAlmacenaje Aire, originando un riesgo de ruptura de sus paredesGarantía Limitada Esta Garantía no CubreManuel Compresseurs Mesures DE Sécurité Définitions Consignes DE Sécurité ImportantesOu la mort MoyennesConserver CES Directives Risque D’EXPLOSION OU D’INCENDIERisque D’ÉCLATEMENT Risque DE Projection D’OBJETSRisque DE Choc Électrique Risque PAR InhalationRisque DE Brûlures Risque Relié AUX Pièces MobilesRisque DE Chute Risque Dune Utilisation Dangereuse Glossaire NO. DE Modèle CFFAC2600PMontage DE Lappareil Directives DE Mise À LA TerreRallonges Protection contre la surtension et protection du circuitUtilisation Familiarisez-vous avec votre compresseur dairDescription du fonctionnement Utilisation de lappareil Arrêt de lappareilAvant le démarrage Avant chaque mise en marche Mise en marcheEntretien Responsabilités du clientVérification de la soupape de sûreté Vidange du réservoirRemplacement ou nettoyage de la soupape de retenue Entretien ET RéglagesDébranchez le compresseur dair Remplacement du régulateur Rangement D27856 D27856 Garantie Limitée Cette Garantie NE Couvre PAS CE QUI Suit

CPFAC2600P specifications

The Porter-Cable CPFAC2600P is a versatile and powerful air compressor designed for both DIY enthusiasts and professionals alike. Known for its robust performance and innovative features, this model has garnered attention in the competitive landscape of portable air compressors.

At the heart of the CPFAC2600P is its 26-gallon vertical tank, which efficiently stores air to power a variety of tools. This larger capacity allows it to deliver a sustained airflow, making it suitable for tasks that require consistent pressure. Whether you're inflating tires, powering nail guns, or operating paint sprayers, this compressor stands up to the challenge.

One of the standout characteristics of the CPFAC2600P is its impressive 1.6 horsepower motor. This motor delivers a high CFM (cubic feet per minute) rating, ensuring that users have sufficient air supply for fast recovery times and reduced downtime on the job. The direct-drive pump design also contributes to its overall efficiency, reducing wear and prolonging the lifespan of the compressor.

Porter-Cable has integrated several user-friendly features into the CPFAC2600P. One notable feature is the easy-to-read pressure gauge, which allows for precise monitoring of air pressure in the tank. Additionally, the dual-regulator system gives users the flexibility to set different pressures for various applications, enhancing its versatility.

Safety is another significant consideration with the CPFAC2600P. The unit is equipped with thermal overload protection to prevent motor damage due to overheating. Furthermore, the durable construction and stable base ensure that the compressor remains upright and secure during operation, minimizing the risk of accidents.

Compact and portable, the CPFAC2600P features ergonomic handles and a lightweight design, which make it easy to transport from one job site to another. The rubber feet also provide excellent stability and help to dampen vibration during use.

In conclusion, the Porter-Cable CPFAC2600P stands out in the air compressor market due to its powerful motor, large tank capacity, and user-friendly features. Its combination of safety measures, portability, and versatility make it an excellent choice for both casual users and professionals striving for reliable performance. With the CPFAC2600P in your toolkit, you will be well-equipped to tackle a wide range of air-powered tasks efficiently and effectively.