Powermatic M-1791257 operating instructions

Page 6

21.Give your work undivided attention. Looking around, carrying on a conversation and “horse-play” are careless acts that can result in serious injury.

22.Maintain a balanced stance at all times so that you do not fall or lean against the blade or other moving parts. Do not overreach or use excessive force to perform any machine operation.

23.Use the right tool at the correct speed and feed rate. Do not force a tool or attachment to do a job for which it was not designed. The right tool will do the job better and safer.

24.Use recommended accessories; improper accessories may be hazardous.

25.Maintain tools with care. Keep blade sharp and clean for the best and safest performance. Follow instructions for lubricating and changing accessories.

26.Turn off the machine before cleaning. Use a brush or compressed air to remove chips or debris — do not use your hands.

27.Do not stand on the machine. Serious injury could occur if the machine tips over.

28.Never leave the machine running unattended. Turn the power off and do not leave the machine until it comes to a complete stop.

29.Remove loose items and unnecessary work pieces from the area before starting the machine.

Familiarize yourself with the following safety notices used in this manual:

This means that if precautions are not heeded, it may result in minor injury and/or possible machine damage.

This means that if precautions are not heeded, it may result in serious injury or possibly even death.

- - SAVE THESE INSTRUCTIONS - -

6

Image 6

Contents 20and 24 Band Saws Warranty and Service Warranty PeriodTable of Contents Page Page Page Introduction Specifications 2013Features and Terminology Floor DiagramsContents of the Shipping Container UnpackingAssembly Installing Fence and RailsPage Grounding Instructions Dust CollectionVolt, Single Phase Operation Volt, Three Phase OperationExtension cords Converting from 230 Volt to 460 Volt Three Phase Only Three-Phase Test RunAdjustments Table TiltTable Stop Installing/Changing Blades Blade TensionBlade Tracking Upper Blade Guide Assembly Upper Blade Guides and Upper Support BearingLower Blade Guides and Lower Support Bearing Miter Gauge Belt TensionBlade Speed Adjustment Operating ControlsBelt Alignment General Procedure OperationBrake Pedal Resawing RippingCrosscutting Blade LeadBlade Selection Width PitchShape Set MaterialMaintenance Tire ReplacementBand Wheel Replacement Blade Selection Guide For Radius CuttingTroubleshooting Operational Problems Trouble Troubleshooting Mechanical and Electrical Problems Replacement Parts Trouble Probable Cause RemedyParts List Saw Body Assembly 2013 Band Saw Index No. Part No Description Size QtyParts List Saw Body Assembly 2415 Band Saw 2415-102ORNSaw Body Assembly 2013 Parts List Table Assembly 2013 Band Saw Index No. Part No Description Size Qty Parts List Table Assembly 2415 Band Saw Index No. Part No Description Size Qty Table Assembly 2013 Parts List Upper Wheel Base Assembly 2013 Band Saw For 2013-3, serial #01062013090 toParts List Upper Wheel Base Assembly 2415 Band Saw For 2415-3, serial #01062415011 toUpper Wheel Base Assembly 2013 Parts List Lower Wheel Base Assembly 2013 Band Saw ST 18AWG Parts List Lower Wheel Base Assembly 2415 Band Saw 2013-459 Limit Switch Cord not shown Lower Wheel Base Assembly 2013 Parts List Guide Bracket Assembly 2013 Band Saw Index No. Part No Description Size Qty Parts List Guide Bracket Assembly 2415 Band Saw Index No. Part No Description Size Qty Guide Bracket Assembly 2013 Motor Band Saw onlyMagnetic Switch Electrical Connections 230 Volt, 3 Phase Models 2013 Electrical Connections 460 Volt, 3 Phase Models 2013 This page intentionally left blank This page intentionally left blank