
2.Attach the four short braces to one set of legs as shown in Figure 6.
3.Complete the stand assembly by attaching the other set of legs as shown in Figure 7.
4.To attach rubber feet to each leg, first use a
5.Remember, leave all other stand assembly nuts only finger tight!
Mounting Saw to Stand
Tip: Remove all contents from carton except saw and one extension wing. Put some soft padding on floor beside box. Fold back carton flaps and gently roll carton upside down on to padding. Lift off carton, being careful not to let extension wing fall.
1.Place table top upside down with its surface on a flat floor, and place stand, with legs upside down, atop the cabinet. See Figure 9
2.Align the holes of stand with holes on bottom flange of saw base and tightly secure with four
3.Carefully raise the machine to its upright position.
4.With the saw located at the place of operation, (with a solid foundation), spread the stand legs to
NOTE: If the saw is to be used without the metal stand provided, care must be taken to provide a hole in the stand or bench used by the operator to facilitate the removal of sawdust.
If there is any tendency to slide, walk, or tip over during operation, the stand or bench MUST be secured to the floor.
Figure 7
Figure 8
Figure 9
11